Hot compression tests were conducted on a Gleeble-3800 machine in a temperature range of 950 to 1 200℃ and a strain rate range of 0.001 to 10s-1 in order to study the hot deformation behaviour of superaustenitic stainless steel 654 SMO.The results show that peak stress increases with decreasing temperature and increasing strain rate,and the apparent activation energy of this alloy was determined to be about 494kJ/mol.The constitutive equation which can be used to relate the peak stress to the absolute temperature and strain rate was obtained.The processing maps for hot working developed on the basis of flow stress data and the dynamic materials model were adopted to optimize the hot workability.It is found that the features of the maps obtained in the strain range of 0.2 to 1.0 are fundamentally similar,indicating that the strain does not have a substantial influence on processing map.The combination of processing map and microstructural observations indicates that the favorable hot deformation conditions are located in two domains of processing map.The first domain occurs in the temperature range of 980 to 1 035 ℃ and strain rate range of 0.001 to 0.01s-1 with a peak efficiency of 55%.The second domain appears in the temperature range of 1 120 to 1 180℃ and strain rate range of 0.3 to 3s-1 with peak efficiency of 35%.Compared to other stable domains,the specimens deformed in these two domains exhibit full dynamic recrystallization grains with finer and more uniform sizes.An instability domain occurs at temperatures below 1 100℃ and strain rate above 0.1s-1,and flow instability is manifested in the form of flow localization. Hot compression tests were conducted on a Gleeble-3800 machine in a temperature range of 950 to 1 200 ° C and a strain rate range of 0.001 to 10s-1 in order to study the hot deformation behavior of superaustenitic stainless steel 654 SMO.The results show that peak stress increases with decreasing temperature and increasing strain rate, and the apparent activation energy of this alloy was determined to be about 494 kJ / mol. the constitutive equation which can be used to relate the peak stress to the absolute temperature and the strain rate was The processing maps for hot working developed on the basis of flow stress data and the dynamic materials model were applied to optimize the hot workability. It is found that the features of the maps obtained in the strain range of 0.2 to 1.0 are fundamentally similar, indicating that the strain does not have a substantial influence on processing map. the combination of processing map and microstructural observations says that the favorable hot deformation conditions are located in two domains of processing map. The first domain occurs in the temperature range of 980 to 1 035 ° C and strain rate range of 0.001 to 0.01s-1 with a peak efficiency of 55%. second domain appears in the temperature range of 1 120 to 1 180 ° C and strain rate range of 0.3 to 3s-1 with peak efficiency of 35% .Compared to other stable domains, the specimens deformed in these two domains exhibit full dynamic recrystallization grains with finer and more uniform sizes .An instability domain occurs at temperature below 1 100 ° C and strain rate above 0.1s-1, and flow instability is manifested in the form of flow localization.