过去,对跑内圈磨损的联动机皮带轮轴,常采用镶套法修复。从2000年3月开始,我们采用北京天山新材料技术开发公司生产的可赛新系列产品进行粘补修复。具体作法如下: 1.对磨损量小于0.5mm的轴,把轴清洗干净,均匀涂上可赛新TS1680少许,装上轴承,固化后即可投入使用。 2.对磨损量在0.5～4mm的轴,采用可赛新TS215修复,具体步骤是:(1)用车床或手工对待修表面进行粗化处理,并用丙 In the past, running on the inner wear and tear of the linkage of the pulley shaft, often using set method to repair. From March 2000 onwards, we use the new material technology development company in Beijing Tianshan Corsa new series of products for sticky repair repair. Specific practices are as follows: 1. Wear on the shaft less than 0.5mm, the shaft clean, evenly coated with a new race can be a little new TS1680, fitted with bearings, curing can be put into use. 2. Wear on the axis of 0.5 ~ 4mm, the use of new race can be repaired TS215, the specific steps are: (1) lathe or manual repair of the surface roughening treatment, and C