【摘 要】
：
The long trace profiler (LTP) is proposed to measure radius of curvature (R) and surface figure of a longradius spherical surface in an optical shop. Equipped with a motorized rotary stage and a two-dimensional tilt stage, the LTP scans the full aperture
【机 构】
：
ChengduFineOpticalEngineeringResearchCenter,Chengdu610041,China
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
The long trace profiler (LTP) is proposed to measure radius of curvature (R) and surface figure of a longradius spherical surface in an optical shop. Equipped with a motorized rotary stage and a two-dimensional tilt stage, the LTP scans the full aperture and calculates the absolute radius of curvature of each scanning line based on the least square method. Nonlinear error and manufacture error difference between center and the edge are obtained by comparing R results. The R-limit is validated and expressed as D/R, where D is the aperture of the mirror under test. A full-aperture three-dimensional figure is also reconstructed based on triangle interpolation.
其他文献
对各种非线性光学应用来讲,背向喇曼散射放大器是一种受欢迎的对象.本文为小型系统的设计给出了有正向散射反馈的背向喇曼放大器的理论.它可用来估计实验的主要定性特征.
A simple and efficient templating method in combination with hot embossing technique is developed for fabricating large-area two-dimensional (2D) microlens arrays (MLAs) with uniform shape. By utilizing a modified microchannel method, a 2D large-area hexa
We propose and experimentally demonstrate a novel scheme to realize polarization-division-multiplexing quadrature-phase-shift-keying (PDM-QPSK) signal transmission over fiber, wireless and fiber at W-band (75-110 GHz). The generation of polarization multi
We propose a 40-Gb/s star 16-ary quadrature amplitude modulation (16-QAM) transmitter using a single dual-drive Mach-Zehnder modulator (DDMZM). This transmitter is demonstrated through experiment and simulation and shows the advantage of simplicity for im
提出一种基于分布反馈光注入锁定效应的可调谐光电振荡器, 其环路主要由马赫曾德尔调制器、光电探测器、环形器、分布反馈激光器和射频放大器顺接而成.分布反馈激光器是系统关键器件, 通过分布反馈激光器光注入锁定效应, 分布反馈腔在光域实现了微波光子滤波器功能, 无需传统光电振荡器必须的射频带通滤波器.同时, 由于分布反馈激光器注入锁定提高了环路Q值, 因此系统可采用短环路结构, 从而降低了光纤因温度敏感对微波信号稳定性的影响并减小了整个系统的尺寸.另外, 通过调节注入光波长和功率可改变该微波光子滤波器的中心频率,
This short note covers some of my favorite scientific accomplishments of Britton Chance
采用标准光荧光方法,在不加入探针或荧光、磷光染料的情况下,测量了具有56个和29个碱基的两种核酸单链样品的光致发光特性;该方法不会对样品造成破坏或污染。结果表明:当激发波长在310~410 nm之间时,能够在410~480 nm波长区间观测到样品明显的发光峰;两种样品的发光峰随着抽运波长的红移而红移,且发光峰的强度随激发波长的增加而先增强后减弱;具有两种不同碱基数和序列的核酸样品由于具有不同的电子能级结构而显示出了不同的光致发光特性,原理上可以用于甄别两种不同的核酸材料,有助于单链核酸样品的无损、无标记检
本文探讨了射频(RF)激励快轴流CO2激光器单源多极激励的串行系统,给出了系统的均压设计方法和系统频率负载特性。
Dual-chirped difference frequency generation (DFG) is an advantageous technique for generating the broadband mid-infrared (IR) idler wave, which is inaccessible by a population-inversion-based laser system. In principle, the generated idler wave may even