造纸网与一般工业网在纹理结构上有所不同,造纸网的纬线粗,经线细,成网后纬线保持平直,只有经向弯曲,没有纬向弯曲,因此,可采用如下的剪切和钎焊工艺。焊前剪切与焊料装配网的两端用剪刀与网平面成80°～85°的交角沿同一根纬线剪下,并使上层经线长于下层经线,如图1所示。 The papermaking net and the general industrial net are different in the textural structure. The weft of the papermaking net is thick, the warp is thin and the weft is straight after the netting. Only the warp is warp and no warp is bent. Therefore, the following shearing and Brazing process. Pre-weld shear and solder assembly at both ends of the net with scissors and the plane at an angle of 80 ° ~ 85 ° along the same cut along the latitude, and the upper warp length longer than the lower warp, shown in Figure 1.