在总结近10年的现浇钢筋混凝土模板工程的基础上,对今后现浇钢筋混凝土模板的发展,本人有以下几点设想。一、进一步发挥现有组合钢模的优势,用好管理好组合钢模 1.采用合理施工工艺,要尽量避免采用散拆、散装工艺,采取预制整体安装工艺,一次组装后多次周转使用,实行整体安装、整体拆除、整体转移,减少模板的损耗,加快施工进度,提高劳动效率,尤其是在墙柱工程中更应普遍推广。 2.加强对组合钢模的管理。最好实行租 Based on the summary of nearly 10 years of cast-in-place reinforced concrete formwork engineering, I have the following ideas for the development of cast-in-place reinforced concrete formwork in the future. First, to further give play to the advantages of the existing combination of steel mold, good use of a good management of the combination of steel mold 1. Using reasonable construction techniques, it is necessary to try to avoid the use of loose, bulk process, to adopt a prefabricated overall installation process, a number of turnover after the use of an assembly, The overall installation, overall demolition, and overall transfer are implemented to reduce the loss of the formwork, speed up construction progress, and improve labor efficiency, especially in wall columns. 2. Strengthen the management of combined steel molds. It is best to rent