论文部分内容阅读
Effects of Rare Earth Oxides on Viscosity,Thermal Expansion, and Structure of Alkali-Free Boro-Alumi
【机 构】
：
State Key Laboratory of Silicate Materials for Architectures, Wuhan University of Technology, Wuhan
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
【发表日期】
：
2017年1期
其他文献
Magnetically Recoverable PEI/Titanate@Fe3O4 Photocatalysts: Fabrication and Photocatalytic Propertie
The magnetically separable ternary polyetherimide/titanate@Fe3O4 (PTF) photocatalysts of special heterostructure between magnetite (Fe3O4) microspheres and titanates nanosheets modified by polyetherimide (PEI) were successfully fabricated via a simple fac
Combined Effects of Pre-deformation and Pre-aging on the Mechanical Properties of Al-Cu-Mg Alloy wit
The combined effects of pre-deformation and pre-aging on the mechanical properties of Al-Cu-Mg alloy with Sc and Zr addition were investigated. It is revealed that the introduction of pre-deformation can enhance the peak-aging strength, as well as tensile
Microstructures and Thermal Properties of Sn–Bi–Zn–Ga Alloys as Heat Transfer and Heat Storage Mater
Low melting point alloy is a potential high-temperature heat transfer medium because of the high thermal conductivity, low solidus temperature and wide range of use temperature. Consequently, we investigated the possibility of using Sn–Bi–Zn–Ga alloys as
Functionalized graphene nano-platelets (FGN) were obtained via treating graphene nanoplatelets (GN) with HNO3, and served as adsorbent for the removal of Pb2+ from solutions. We investigated the FGN adsorption capacity for Pb2+ at different initial concen
Influence of Hydrothermal Synthesis Conditions on the Formation of Calcium Silicate Hydrates:from Am
Hydrothermal treatment has been widely applied in the synthesis of well crystalline calcium silicate hydrate(CSH),such as tobermorite and xonotlite.However,both morphology and crystallinity of CSH are greatly affected by the conditions of hydrothermal tre
Synergistic Corrosion Inhibition Effect of Molybdate and Phosphate Ions for Anodic Oxidation Film Fo
In order to effectively improve the corrosion resistance of aluminum alloys, anodic oxidation technique was used to generate the oxide film. We investigated the influences of two inorganic corrosion inhibitors (ammonium dihydrogen phosphate and sodium mol
Effect of Interface Friction on Overlapping Sheets Bulging Formability and Microstructure of 5AO2 Al
Aluminum alloy 5A02 with low plasticity was used as target sheet,and stainless steel SUS304 with good plasticity was used as overlapping sheet to investigate the effect of interface friction on bulging formability and microstructure of target sheet in ove
The sintering of chromium-containing vanadium-titanium magnetite using different coke contents was studied through the sintering pot tests, X-ray diffraction analysis and mineralogical phase analysis. Results showed that, as the coke content increased fro
Separation of aluminum from fine granules of black dross,which is a waste by-product in secondary aluminum production,was investigated.The separation was performed by a multi-stage electrostatic separation method.There are three stages to complete the sep
To improve the low thermal conductivities and poor wear resistances of TC4 (Ti-6Al-4V) alloy, the most widely used titanium alloy, the surface of TC4 alloys is modified by electroplating deposition of Ni and Cu layers, and then heat-treated to increase th