HIGH TFMPERATURE CORROSION-EROSION BEHAVIOR OF SOME Cr-BEARING STEELS

来源 :Acta Metallurgica Sinica(English Edition) | 被引量 : 0次 | 上传用户:romeolg
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
It was shown from the laboratory data that high temperature corrosion-erosion(C-E)resistance of some commercial Cr bearing steels strongly depended on their corrosion re-sistance.The C-E resistance increased with increasing of Cr content in steels,which isobviously improved at 850℃ when Cr content is up to 9wt-%.Meanwhile,nature andshape of erodant particles had a significant influence on the C-E rate of steels.Mecha-nisms of degradation of materials had been put forth. It was shown from the laboratory data that high temperature corrosion-erosion (CE) resistance of some commercial Cr bearing steels strongly depended on their corrosion re-sistance. The CE resistance increased with increasing of Cr content in steels, which was significantly improved at 850 ° C when Cr content is up to 9wt -%. Meanwhile, nature andshape of erodant particles had a significant influence on the CE rate of steels. Mecha-nisms of degradation of materials had been put forth.
其他文献
高铬白口铸铁有优异的耐磨性能,但性脆(αK值约为2.9,4.9J/cm~2)不能承受冲击,应用范围有限。太原工业大学从金属学理论角度提出用锻造变形方法来改变共晶碳化物在基本组织
企业闯市场必须打出自己的品牌,艺术表演团体走向市场同样要创出自己的特色品牌,这既是市场规律,也是艺术自身发展规律。这几年,通榆县剧团打自己的特色品牌,搞旅游开发演出,
压塑机刀片材料为CrWMn,要求硬度HRC60~62、变形≤0.2毫米,原采用820~840℃盐炉加热后油淬、硝盐淬,变形超差多,冷校直易脆断,利用马氏体相变超塑性热校,回火后仍有40~50%的刀片
介绍了活塞偏心套车机床的工作原理和活塞裙部各种椭圓的极坐标方程,给出了加工二次变椭圆活塞时机床调整参数的计算步骤和方法。 This paper introduces the working princ
Q3025抛丸器是一种使用较为广泛的抛丸器,但其进丸管的固定方式却不尽如意(见图左)。由于抛丸器本身的严重振动,进丸管2常因松动而转动,即使再紧固顶紧螺钉4也无济于事。我
衡量一个民族、一个地域、一个时代文化艺术的成败荣枯,最根本的一点,要看是否创造并留下了真正属于那个民族、那个地域、那个时代的不朽的或相对具有生命力的人物形象。这
在设计每一道板材冲压的分离工序时,都必须选择冲模的工艺示意图,规定毛坯的定位尺寸,凹凸模工作部位的配合尺寸,确定工序尺寸等。这些问题,都可以通过尺寸链加以解决。一般
实型铸造法是1958年出现的,美国HaroldF·Shroyer先生获得了这种方法的专利。联邦德国的市依得莫扎等人于1962年将其用于工业生产。在近二十年的时间里,由于专利权的限制,没
Atomic structures of.four Σ=17(530)/[001]symmetrical boundaries in Cu con-taining segregated Bi atoms at different sites have been studied.The segregation ind
本功法通过暝想入静,达到调息通经的目的,对于各虚弱病人有较好的强壮气血的作用。 坐在凳上三寸,露出会阴,上身与大腿成90度或大于90度,大腿与小腿成90度或大于90度,两脚平