本人对“药液自动分裝器”的設計又作了一点改进,写在下面,作为对原文的补充。把裝置瓶(即“貯液瓶”)改为下口裝置瓶。在下口的瓶塞上鑽一孔,插入短玻璃管,玻璃管再与一短橡皮管連接,橡皮管再用夾子紧閉。为了使液位控制瓶中的液位升高以注滿虹吸管形成虹吸,只要开啓夾子,使大气进入貯液瓶就可以了。当各虹吸管都有药液流出时,立即紧閉。这样,不但省去了把手,拉繩和滑车,而且当灌注液量大(如药厂情况下)时,还可以克服下拉把手过于费力的缺点。 I also made some improvements to the design of the “liquid automatic dispenser” and wrote it below as a supplement to the original text. Change the device bottle (ie, “buffer bottle”) to the lower device bottle. A hole is drilled in the lower cork, a short glass tube is inserted, the glass tube is connected with a short rubber tube, and the rubber tube is closed with a clip. In order to raise the liquid level in the liquid level control bottle to fill the siphon to form a siphon, it is only necessary to open the clamp to allow the atmosphere to enter the liquid reservoir. When all siphons have liquid outflow, they are immediately closed. In this way, not only the handle, the pull rope and the trolley are omitted, but also when the liquid volume is large (such as in the case of a drug factory), the disadvantage that the pull-down handle is too laborious can be overcome.