【摘 要】
：
It is approved that grain boundary diffusion is an effective method to increase the coercivity of hot-deformed NdFeB magnet.In this paper,a new rare earth-free grain boundary diffusion source of hot-deformed magnet was studied.AlCuZn powders blended with
【机 构】
：
National Engineering Research Center for Rare Earth Materials,General Research Institute for Nonferr
论文部分内容阅读
It is approved that grain boundary diffusion is an effective method to increase the coercivity of hot-deformed NdFeB magnet.In this paper,a new rare earth-free grain boundary diffusion source of hot-deformed magnet was studied.AlCuZn powders blended with commercial NdFeB powders were hot-compacted to obtain fully dense mag-nets,hot-deformed into anisotropic magnets and finally annealed to gain better homogeneity.Initially,the influ-ences of annealing temperature and time on the magnetic properties of the specimens were studied and the optimal parameters of 600 ℃ and 60 min were achieved.Then,by changing the proportions of AlCuZn grain boundary dif-fusion,the coercivity,remanence and maximum energy product of the hot-deformed NdFeB magnets were exam-ined.The result showed that with 1.0 wt％ AlCuZn grain boundary diffusion and annealing at 600 ℃ for 60 min,the coercivity rose from 828 to 987 kA·m-1 without deterio-rating the remanence.Microstructural analysis confirmed that AlCuZn diffused into the intergranular boundaries and the magnet diffused with AlCuZn possessed finer grains than that of without AlCuZn grain boundary diffusion.
其他文献
The increasing antibiotic treatment failure is attributed to the increasing emergence of drug-resistant bacteria,and the attachment of these bacteria to the surface of implantation materials often leads to dangerous bacterial biofilm formation on the impl
In this work,a comparative study of three fre-quently employed modification techniques to g-C3N4 (CN)nanosheets for the photocatalytic degradation of metribuzin(MET) under visible-light irradiation has been carried out in detail.The modification methods w
Acinetobacter baumannii and methicillin-resis-tant Staphylococcus aureus (MRSA) are two prevalent pathogens and have developed high resistant to most antibiotics.Therefore,it is a pressing need to develop a new method to inhibit the spread of drug-resista
Copper (Cu)-bearing stainless steel has testified its effectiveness to reduce the risk of bacterial infections.However,its antibacterial mechanism is still controversial.Therefore,three 430 ferritic stainless steels with different Cu contents are selected
Various solid state phase transformations exist in metastable β-type Ti alloys,which can be employed to optimize the mechanical properties.In this paper,syn-chrotron X-ray diffraction (SXRD) experiments were car-ried out to study the phase transformations
In this paper,a silvered gradient nanostructured(GNS) layer was successfully fabricated on Ti6Al4V surface by means of surface ultrasonic rolling treatment (SURT)combined with silvering process.Surface characteristics,mechanical properties,corrosion resis
Ti-Cu alloy has potential to be used in plastic surgery and dental implants due to its strong antibacterial properties,high strength and good corrosion resistance.In this paper,Ti-5Cu was anodic-oxidized to enhance the surface compatibility.The influence
To analyze the magnetic properties of Nd2Fe14B compound under high pressure,an improved two-sublattice molecular field model coupled with equivalent stress field was applied to study the effect of pressure on magnetiza-tion,magnetostriction coefficient,su
In this study,yttrium as desulfurizer on the purification of Ni-20Co-20Cr-10Al-Y alloy during vac-uum induction melting (VIM) process using Y2O3 cru-cibles was investigated experimentally.It is found that Y plays an important role on the desulfurizing of
Pathogenic bacteria have been threatening the daily life of human beings.More effective methods without causing drug-resistance of bacteria need to be developed to fight against these pathogens.Herein,flower-like CuS/-graphene oxide (GO) hybrids have been