论文部分内容阅读
Ⅵ型钢轨推凸机系全钢结构,可以承受推凸作业时的各种作用力。端板上装有夹钳油缸、推凸油缸和滑道。钢轨移动是在进、出口和中间三个滚轴上进行的。液压定位器能确定钢轨在机器中的位置。整个推凸机安装在基板上,并且装有液压和电器控制盘。基板下装有四个钢轮,轮距为1,435毫米,可以开动。这种钢轨推凸机可以处理不同类型的钢轨(包括78公斤/米钢轨),能在离焊头一根钢轨长处推凸。夹钳是用液压控制的,其夹紧力最大可达到180吨。用一个单独的50马力发动机带动油泵可提供69巴(1巴=1.020公斤/厘米。)的压力。夹钳打开,钢轨通过机器,焊接凸出量即被清除干净。
Ⅵ rail push convex machine all-steel structure, you can withstand push-convex operation of a variety of force. The end plate is equipped with clamp cylinder, push the fuel tank and slide. Rail movement is carried out on the entrance, exit and middle three rollers. The hydraulic positioner determines the position of the rail in the machine. The whole push-convex machine is mounted on the base plate, and equipped with hydraulic and electrical control panel. Four steel drums are mounted under the base, with a wheelbase of 1,435 mm, which can be actuated. This rail jogger can handle different types of rails (including 78 kg / m rail) and can push a rail length away from the head. Clamps are hydraulically controlled and have a clamping force of up to 180 tons. A single 50 hp engine drives the pump to provide 69 bar (1 bar = 1.020 kg / cm.) Of pressure. Clamps open, the rail through the machine, the amount of welding projection is removed clean.