【摘 要】
：
Apatite coating with nanobelt structure was fabricated on single crystal silicon by a two-step method of electrodeposition at 1.0-2.0 mA/cm2 with DC power and v
【机 构】
：
College of Chemistry and Chemical Engineering,College of Materials Science and Engineering
论文部分内容阅读
Apatite coating with nanobelt structure was fabricated on single crystal silicon by a two-step method of electrodeposition at 1.0-2.0 mA/cm2 with DC power and vapor-thermal treatment (VTT) at 150-180 °C for 6 h over alkali medium. Scanning electron microscopy (SEM), X-ray diffractometry (XRD), and electron diffraction spectrometry (EDS) were employed to investigate the compositions and morphologies of specimens before or after vapor-thermal treatment. The results demonstrate that nanobelt crystals of coating, 0.5-2 μm in width, 100 nm in thickness, and 6-10 μm in length, are Ca-deficient apatite (CDA) with a mole ratio of Ca to P approximately of 1.60, which shows similarity of the nanobelt coating to inorganic phase in composition and to collagen in dimension appearing in human hard tissue. Induced nucleation and growth of bone-like apatite were observed on the nanobelt after soaking in a simulated body fluid (SBF) for 6 h and for 3 d, respectively, identifying that nanobelt has good ability for induction of bone-like apatite in SBF.
其他文献
采用固体超强酸SO_4~(2-)/TiO_2-Fe_2O_3为光催化剂,苯酚的光催化降解为模型反应,考察了pH值、苯酚初始浓度、催化剂投加量、光照距离、光照时间、助催化剂H_2O_2对光催化降
为了对某电厂灰渣库运行情况进行安全性评价,通过综合分析灰渣坝库区地形地貌、地层岩性、水文地质条件及灰渣坝现状,采用数值模拟方法对储灰场边坡的稳定性进行了分析,结果
A series of hydrogen storage Co-free AB3-type alloys were directly synthesized with vacuum mid-frequency melting method, within which Ni of La0.7Mg0.3Ni3 alloy
The effects of temperature on atomic anti-site behaviors in L12-Ni3(AlFe) phases were studied using microscopic phase-field dynamic model in precipitation progr
1-butyl-3-methylimidazolium perchlorate ([BMIM]ClO4) was synthesized by two steps with N-methylimidazolium. Some physico-chemical properties, such as density, s
Deep drawing is one of the most important processes for forming sheet metal parts.It is widely used for mass production of cup shapes in automobile,aerospace an
Al-Cu alloy was deformed through equal channel angular pressing (ECAP) by routes A, Ba, Bc and C up to 5 passes. ECAP was done using a 90° die for three differ
Extraction of copper and ammonia from Cu2+-NH3-Cl--H2O solution using laboratorialy synthesized sterically hindered β-diketone (4,4-dimethyl-1-(4-dodecylphenyl
Mg-6%Al-5%Pb and Mg-6%Al-5%Pb-0.55%Zn-0.22%Mn (mass fraction) alloys were prepared by induction melting with the protection of argon. The corrosion behaviors of
CuO was synthesized by thermal decomposition of Cu(NO3)2·3H2O at various temperatures and characterized by powder X-ray diffractometry (XRD) as well as scannin