有些铣床常用小三爪卡盘来夹持立铣刀进行铣削。小三爪卡盘夹持的缺点是在铣削分力的作用下,立铣刀容易被拉出或打滑。通常的解决办法是尽可能地夹紧立铣刀,减少铣削用量,同时还要注意观察,避免事故。本方法是利 Some milling machines often use a small three-jaw chuck to hold the end mill for milling. Small three-jaw chuck clamping shortcomings is the role of milling force, the end mill easily pulled out or slip. The usual solution is to clamp the end mill as much as possible to reduce the amount of milling, but also observe and avoid accidents. This method is beneficial