【摘 要】
：
A sub-microstructure titanium aluminide alloy /Al2O3 (3A) composite was obtained by crystallization of the amorphous powders, which were prepared by mechanical
【机 构】
：
State Key Laboratory for Mechanical Behavior of Materials,School of Materials Science and Engineerin
论文部分内容阅读
A sub-microstructure titanium aluminide alloy /Al2O3 (3A) composite was obtained by crystallization of the amorphous powders, which were prepared by mechanical alloying (MA) in a planetary ball milling system using Ti-Al-TiO2 as raw materials. The experimental results show that, when the milling time increases up to 30 h, the hcp Ti(Al) supersaturated solid solution disappears, only amorphous phase is left. The compact samples were synthesized by hot-press to 1 200 ℃ with the amorphous as a precursor; the final phases of the matrix and strengthened phase are γ-TiAl and Al2O3. The phases come from in situ crystallization and transformation. The samples, fabricated from the amorphous phase by hot press sintering, have high bending strength and fracture toughness.
其他文献
Employing isothermal and isochronal differential scanning calorimetry, an analytical phase transformation model was used to study the kinetics of crystallizatio
The packaging poses a critical challenge for commercialization of MEMS products. Major problems with the packaging process include degraded reliability caused b
The precursor precipitation of InVO4 was synthesized by co-precipitation using indium trichloride (InCl3),ammonium metavanadate (NH4VO3) and ammonia (NH3-H2O) a
Ferroelectric devices are widely applied in many fields, such as energy conversion and communication. The aging effect in ferroelectric materials plays a centra
Solid oxide fuel cell is attracting more attention in recent years for its lower pollution emission and high energy convert efficiency. La0.9Sr0.1Ga0.8Mg0.2O3-
The preparation technology and magnetic properties of Nd9.5Fe77B6Co5Zr2.5 nanocomposite magnets were investigated by melt spinning and crystallization process.
Composite metastable TiN and Ti1-xAlxN coatings with different Al content were deposited on 1Cr11Ni2W2MoV stainless steel for aero-engine compressor blades by a
A research project was conducted to manufacture eco-cement for sustainable development using cement kiln dust( CKD ) and granular blast furnace slag( GBFS ).In
ZnO nanoparticles in porous anodized alumina were fabricated by sol-gel method. The PL spectra of pure ZnO nanoparticles, porous alumina template and the ZnO/PA
Zn1-xCoxO films were grown on glass by sol-gel spin coating process. A homogeneous and stable Zn1-xCoxO sol was prepared by dissolving zinc acetate dihydrate, c