Pressure-swirl atomizers are often employed to generate a water-mist spray,typically employed in fire suppression.In the present study,an experimental characterization of dispersion(velocity and cone angle)and atomization(drop-size axial evolution)was carried out following a previously developed methodology,with specific reference to the initial region of the spray.Laser-based techniques were used to quantitatively evaluate the considered phenomena:velocity field was reconstructed through a Particle Image Velocimetry analysis;drop-size distribution was measured by a Malvern Spraytec device,highlighting secondary atomization and subsequent coalescence along the spray axis.Moreover,a comprehensive set of relations was validated as predictive of the involved parameters,following an inviscid-fluid approach.The proposed model pertains to early studies on pressure-swirl atomizers and primarily yields to determine both initial velocity and cone angle.The spray thickness is also predicted and a classic correlation for Sauter Mean Diameter is shown to provide good agreement with experimental results.The analysis was carried out at the operative pressure of 80 bar;two injectors were employed featuring different orifice diameters and flow numbers,as a sort of parametric approach to this spray typology. Pressure-swirl atomizers are often employed to generate a water-mist spray, typically employed in fire suppression. In the present study, an experimental characterization of dispersion (velocity and cone angle) and atomization (drop-size axial evolution) was carried out following a previously developed methodology, with specific reference to the initial region of the spray. Laser-based techniques were used to quantitatively evaluate the causes phenomena: velocity field was reconstructed through a Particle Image Velocimetry analysis; drop-size distribution was measured by a Malvern Spraytec device, highlighting secondary atomization and subsequent coalescence along the spray axis. Moreover, a comprehensive set of relations was validated as predictive of the involved parameters, following an inviscid-fluid approach. The proposed model pertains to early studies on pressure-swirl atomsizers and their The result of both initial velocity and cone angle. The spray thickness is also predicted a classic correlation for Sauter Mean Diameter is shown to provide good agreement with experimental results. The analysis was carried out at the operative pressure of 80 bar; two injectors were employed featuring different orifice diameters and flow numbers, as a sort of parametric approach to this spray typology.