• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 会议论文
  5. PrestressedSiC ceramic and its effects on the ballistic performanceof metal-ceramic armor investigat

PrestressedSiC ceramic and its effects on the ballistic performanceof metal-ceramic armor investigat

来源 :第二届中国国际复合材料科技大会 (CCCM-2) | 被引量 : 0次 | 上传用户：lx19880614
【摘 要】
：
Apply stable prestress in the SiC ceramic in SiC-Ti6AL4V 3D confinement metal-ceramic armor system in numerical simulation.Invesitigate the unprestressed and prestressed SiC-Ti6AL4V armor systems anti
【作 者】
：
Chongjian Zhou Qiong Wang Ke Wang Zhongqi Shi GuiWu Liu Guanjun Qiao 
【机 构】
：
College of Material science and engineering,Xi'an Jiaotong University,Xi'an 710049,China
【出 处】
：
第二届中国国际复合材料科技大会 (CCCM-2)
【发表日期】
：
2015年7期
【关键词】
：
Silicon carbide Prestress oblique effect 
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
　　Apply stable prestress in the SiC ceramic in SiC-Ti6AL4V 3D confinement metal-ceramic armor system in numerical simulation.Invesitigate the unprestressed and prestressed SiC-Ti6AL4V armor systems anti-ballistic performance and oblique effect in single layer and double layer metal-ceramic armor under φ12mm×20mm and φ4mm×40mm flat nose bullets impact, respectively.
其他文献
基体位置对CVD SiC涂层微观结构影响规律研究
以国产高纯石墨为基体，一甲基三氯硅烷为先驱体原料，使用化学气相沉积工艺制备了SiC涂层。利用SEM和XRD分别对筒式工装和笼式工装中不同位置所获得涂层的形貌及微观结构进行了表征，并研究了沉积速率、表面形貌、微观结构及堆积缺陷的变化规律。
会议
化学气相沉积碳化硅微观结构涂层
PAS烧结SiC-石墨复相陶瓷的阻力曲线行为和抗热震性能
采用PAS烧结工艺在1680℃成功制备出SiC-石墨复相陶瓷，并研究了石墨含量对复相陶瓷物理力学性能、韧性、R曲线(阻力曲线)行为和抗热震性能的影响。结果 表明：随着石墨含量的增加复相陶瓷的致密度、抗弯强度、弹性模量和维氏硬度均有所降低；以韧化比(TI)作为复相陶瓷的韧性指标，表明石墨含量越多，复相陶瓷的韧性越好，存在陡峭的上升R曲线行为，该指标更能反映复相陶瓷的韧性特征；显微形貌分析发现，复相陶
会议
SiC-石墨复相陶瓷韧性R曲线热震抗力
MoO2/rGO/Ni 3-Dimentional Electrode forHigh-performance Supercapacitor
The nanostructured MoO2/rGO/Ni foam 3-dimentional electrode for supercapacitor is synthesized via a two-step method.First, the graphene oxide (GO) prepared by Hummers method is electrodeposited on nic
会议
Low velocity impact properties of aluminum foam sandwich structurecomposites
Sandwich structure composites were prepared by aluminum foam and basalt fiber, ultra-high molecular weight polyethylene(UHMWPE) fiber composite faceplate.The factors influencing the impact properties
会议
aluminum foamsandwich structurebasalt fibersUHMWPEimpact properties
The effect of substrate position on the microstructure of CVD SiC coating
Silicon carbide coatings were fabricated by chemical vapor deposition method using domestic graphite as substrate and methyltrichlorosilance as precursor.Two frock design: drum type and steamer type,
会议
chemical vapor depositionsilicon carbidemicro-structurecoating
R-curve behavior and thermal shock resistance of SiC-graphite composites prepared by PAS sintering p
SiC-graphite ceramic composites were successfully fabricated by plasma activated sintering (PAS) method at 1680 ℃.The effects of graphite content on the physical mechanical properties, toughness, R-cu
会议
SiC-graphiteCeramic compositesToughnessR-curveThermal shock resistance
Microwave absorption properties of LiZn ferrites hollow microspheres doped with La and Mg by self-re
Lithium-Zinc ferrite hollow microspheres (LiZn FHMs) doped with La, Mg were synthesized by Fe+Zn+Fe2O3+O2+Li2CO3 reactive system based on self-reactive quenching technology.Influence of La, Mg doping
会议
LiZn ferriteMg and La dopinglow frequencymicrowave absorption properties
Optimization of Structure Design Parameters and Mechanical Properties of Mg-Al-Ti Composite Sheets F
The Mg-Al-Ti laminated metal composite sheet combines the advantages of high strength of Ti, light weight, easy melt and atomization of Mg, and good space adaptability of Al.It is well suited to as bu
会议
bonding interfacehot roll bondinglaminated metal composite sheet(LMCS)dissimi
ApplicationsMechanical and thermal properties of reduced graphene oxide reinforced AlNcomposites
High density reduced grapheneoxide (rGO) reinforced aluminum nitride (AlN) composites were successfully fabricated by one-step spark plasma sintering (SPS) method.Raman spectra showed that the raw mat
会议
Reduced graphene oxideAluminum nitrideMechanical propertiesThermal properties
The Preparation and Ablation Propertiesof Three Dimensional Co-continuousSiCp/(Cu-Si) Composites
In this study a porous SiC ceramic reinforced copper-matrix composite was fabricated by mean of pre-sintering of the as-pressed porous SiC preform and spontaneous infiltration of molten Cu-Si alloy in
会议
Porous SiC ceramicsVacuum infiltrationBi-continuous SiC/(Cu-Si) compositeThe