故障现象:一辆川骑ZXR摩托车离合器分离不彻底,经多次调整无效。 故障分析与排除:出现此种现象,一般是由于机油过多,机油浓度偏高,离合器片变形,离合器大鼓磨损过度等引起。本着从简到难的原则,先检查机油液面高度,用塞尺测量机油液面高度,属正常范围并没有多加机油;后检查机油浓度,也不是很浓;放掉机油,加注新机油到标准值,启动发动机,故障依旧;再打开离合器边盖,分解离合器进行检查,经查离合器片没有变形和磨损现象,离合器大鼓也没有过度磨损,那是什么原因造成离合器分离不彻底的呢?经仔细检查发现此车的离合器片有甩油槽,目的是发动机运转后离合器片中的机油通过旋转惯性,从甩油槽甩出去,这样便于离合 Symptoms: a Chuan ZXR motorcycle clutch separation is not complete, after repeated invalidation. Failure Analysis and Troubleshooting: This phenomenon occurs, usually due to excessive oil, high oil concentration, the clutch plate deformation, clutch drum caused excessive wear and tear. In the simple to difficult principle, first check the oil level, with a feeler to measure the level of the oil level, is the normal range and no more oil; After checking the oil concentration is not very strong; let go of the oil, add new oil To the standard value, start the engine, the fault still; then open the clutch cover, clutch decomposition check, the clutch is no deformation and wear check the phenomenon, the clutch drum is not excessive wear and tear, that is why the clutch separation is not complete? After careful examination found that the clutch disc has thrown tank, the purpose is to run the engine clutch oil in the film by rotating the inertia, thrown from the rejection tank, so easy to clutch