论文部分内容阅读
The effect of arc sprayed times, which are quantitatively described by the volume fraction of coatings, on the mechanical properties of type 316 steel, have been undertaken in the present work. Al wires were utilized as coatings materials. Tensile tests were carried out in the temperature range of Portevin-Le Chatelier (PLC) effect It has been found that grains at edges and corners of the 316 steel specimens have been dramatically constricted by grit blasting and spraying. Grit blasting has been found to exert a shot-peening effect on the mechanical properties of 316 steel specimens. Coatings with lower values of coating volume fraction strengthen the coated specimens in the very similar way as blasting. While if the volume fraction of coating, (Vv)c, exceeds a critical value, (VV)K, softens the specimens. Specimens with low values of (Vv)c, have high values of flow stress, as well as higher values of work-hardening coefficient, Calculations based on the experimental results show that the high thickness coatings have relatively lower contribution to the mechanical properties of specimens.
The effect of arc sprayed times, which are quantitatively described by the volume fraction of coatings, on the mechanical properties of type 316 steel, have been undertaken in the present work. Al wires were utilized as coatings materials. Tensile tests were carried out in the temperature range of Portevin-Le Chatelier (PLC) effect It has been found that grains at edges and corners of the 316 steel specimens have been dramatically constricted by grit blasting and spraying. Grit blasting has been found to exert a shot-peening effect on the mechanical properties of 316 steel specimens. Coatings with lower values of coating volume fraction enhance the coated specimens in the very similar way as blasting. While if the volume fraction of coating, (Vv) c, exceeds a critical value, (VV) K, softens the specimens. low dimensions of (Vv) c, have high values of flow stress, as well as higher values of work-hardening coefficient, Calculations based on the experimental results show that the high thickness coatings have relatively lower contribution to the mechanical properties of specimens.