论文部分内容阅读
This paper deals with the output improvement of heating and cooling cycle by using the work-fluid including phase change material.The experimental study is carried out by heat exchange between work-fluid and heat transfer surface.The work-fluid is flown to a high temperature or a low temperature heat transfer surface from the narrow path.In order to increase the amount of the heat transmission,a trace of Diethylether(boiling point 34.8 ℃),as a phase change material(PCM),is added to the work-fluid.The parameters of the experiment are additive amount of PCM,the rotational speed of the displacer piston and the temperature of heat transfer surface.It is clarified that the increasing of engine cycle output is brought by the PCM addition.The effect of PCM addition is evaluated by output ratio which is defined from the experimental cycle output data.The requirements for acquiring the increasing effect of output by adding PCM are clarified.
This paper deals with the output improvement of heating and cooling cycle by using the work-fluid including phase change material. The experimental study is carried out by heat exchange between work-fluid and heat transfer surface. Work-fluid is flown to a high temperature or a low temperature heat transfer surface from the narrow path. In order to increase the amount of the heat transmission, a trace of Diethylether (boiling point 34.8 ° C), as a phase change material (PCM) fluid. these parameters of the experiment are additive amount of PCM, the rotational speed of the displacer piston and the temperature of heat transfer surface. It is clarified that the increasing of engine cycle output is brought by the PCM addition. is evaluated by the output ratio which is defined from the experimental cycle output data. The requirements for acquiring the increasing effect of output are added PCM are clarified.