Measurement of Fluid Flow in Pipe and Porous Media by High-Resolution Magnetic Resonance Imaging

来源 :中国海洋工程(英文版) | 被引量 : 0次 | 上传用户:xiaomayc
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The objective of this study is to understand the process of fluid flow in pipe and porous media with different pore structures.High-resolution Magnetic Resonance Imaging (MRI) technique was used to visualize the pore structure and measure fluid flow.The porous media was formed by packed bed of glass beads.Flow measurement was carried out by a modified spin echo sequence.The results show that the velocity distribution in pipe is annular and the linear relation between MRI velocity and actual velocity is found in pipe flow measurement.The flow distribution in porous media is rather heterogeneous,and it is consistent with heterogeneous pore structure.The flow through pores with the high volume flow rate is determined largely by geometrical effects such as pore size and cross-sectional area.
其他文献
The microstructure and mechanical properties of as-cast Mg-3.8Zn-2.2Ca alloy with different Ce contents were investigated by both optical and electron microscop
采用搅拌摩擦焊实现TCl钛合金和LF6铝合金异种材料的搭接连接,并对界面特性进行研究.采用所选取的工艺参数均能获得良好的表面成形,但每一种工艺参数下的界面形貌不同.随着焊
An analytical method is developed to study the sheltering effects on arc-shaped floating perforated breakwaters.In the process of analysis,the floating breakwat
The Ba1-xSrxMgSiO4:Eu2+,Mn2+ phosphors were prepared by solid-state reaction.Their photoluminescence properties were investigated with fluorescence spectrum and
The lanthana-doped mullite fibers were prepared via a sol-gel method from the aluminum isopropoxide-aluminum nitrate-tetraethyl orthosilicate system.The structu
通过搅拌铸造制备SiC纳米颗粒增强A356铝合金复合材料,并研究其显微组织和力学性能.密度测量发现试样的孔隙度较低,且孔隙度随SiC颗粒体积分数的增加而增加.通过光学显微镜和
The effect of Gd content on microstructure and magnetic properties of sintered Nd33.03-xGdxFe65.65B1.32 (x=0-2) was studied in this paper to improve the thermal
Amorphous La2Hf2O7 thin films were deposited on Si(100) substrate by pulsed laser deposition (PLD) method under different conditions.The interfacial states of t
采用铜填充金属对Ti-15-3钛合金与304不锈钢进行电子束焊接,对Ti/Fe和Ti/Cu/Fe接头在焊接过程中的温度场和应力场进行数值模拟和试验测量.结果表明,高斯旋转体热源适用于电子
An increasing {110} orientation degree behavior was observed during etching of chemical vapor deposition (CVD) diamond films by partially melting Ce-7%Fe alloys.