论文部分内容阅读
通常认为磨机负荷都直接与磨机工作时中空轴轴颈和轴瓦间的润滑油的回油压力有关。现着重就轴承的强迫给油润滑和重力给油润滑这两种方法在连续粉磨设备的给料控制上应用的可能性,以及对这两者的优点进行讨论。从所使用湿式磨机所得的数据以更明确地确定给料浓度,矿浆浓度,磨机负荷,轴承温度,粉磨细度和介质磨损等对控制磨机给料时所测得轴承润滑油回油压力的影响。最后讨论与评价
It is generally considered that the mill load is directly related to the oil return pressure of the lubricating oil between the hollow shaft journal and the bearing shell when the mill is working. The possibilities of applying both the forced lubrication of the bearings and the gravitational lubrication of the bearings to the feed control of the continuous grinding equipment are highlighted, as are the advantages of both. From the data obtained from the wet mills used, it is possible to determine more clearly the bearing lubricant recovery measured at the time of feed to the control mill, including the feed concentration, pulp concentration, mill load, bearing temperature, grinding fineness, and media wear Influence of oil pressure. Final discussion and evaluation