正确的調整插齿机上出口和下出口,对于提高插齿速度,保証齿廓的正确几何形状,起着极为重要的作用。一般調整上、下出口的方法是:把工件固定在工作台上,使工件中心线和插齿刀中心綫在同一垂直面上,然后再使工件靠攏插齿刀,使这两表面母綫最高点距离有2～3毫米間隙为宜,再用肉眼观察和調整上、下出口的位置。根据說明书規定: Proper adjustment of the gear shaper exit and the next exit, to improve the gear speed, tooth profile to ensure the correct geometry, plays an extremely important role. Generally adjust the upper and lower export method is: the workpiece is fixed on the workbench, the centreline of the workpiece and the center line of the gear shaper in the same vertical plane, and then make the workpiece closer together gear shaper, so that the highest of these two surface bus A distance of 2 to 3 mm gap is appropriate, and then the naked eye to observe and adjust the upper and lower exit position. According to the instructions: