2. 您的位置
3. 首页
4. 期刊论文
5. 批量定制柔性生产的数字化、智能化、网络化制造发展

批量定制柔性生产的数字化、智能化、网络化制造发展

来源 :物联网学报 | 被引量 : 0次 | 上传用户：jxjc_2008

【摘 要】

：

数字化、智能化、网络化制造技术与装备是制造强国、网络强国建设的重要基础,是数字化车间、智能化工厂建设的重要工具,赋能制造业转型升级与高质量发展。结合航空航天领域等产品多品种变批量的特点,研究了如何更好实现数字化、智能化、网络化制造,如何更好建设数字制造车间、柔性智能制造工厂。针对单件小批量柔性化生产制造,提出了数字化智能化柔性制造生产线、车间/工厂的建设原则、实施路径和技术架构,可以用于指导建设面

【作 者】

：

单忠德 汪俊 张倩 

【机 构】

：

南京航空航天大学机电学院,江苏 南京 210016;先进成形技术与装备国家重点实验室,北京 100083;南京航空航天大学机电学院,江苏 南京 210016;先进成形技术与装备国家重点实验室,北京 1

【出 处】

：

物联网学报

【发表日期】

：

2021年03期

【关键词】

：

智能制造 网络制造 柔性制造 智能装备 智能工厂 

下载到本地 , 更方便阅读

下载此文 赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

数字化、智能化、网络化制造技术与装备是制造强国、网络强国建设的重要基础,是数字化车间、智能化工厂建设的重要工具,赋能制造业转型升级与高质量发展。结合航空航天领域等产品多品种变批量的特点,研究了如何更好实现数字化、智能化、网络化制造,如何更好建设数字制造车间、柔性智能制造工厂。针对单件小批量柔性化生产制造,提出了数字化智能化柔性制造生产线、车间/工厂的建设原则、实施路径和技术架构,可以用于指导建设面向未来的柔性制造标准化的数字化智能化车间/工厂。通过航空航天领域典型智能工厂建设的探索和应用实践,探索了

其他文献

Study on Squeeze Casting Metal-zirconium Composite Die Material by Hot Press Sintering

ZrO2-5CrMnMo composite samples were prepared by hot press sintering. When NiCoCrAlY powders were used as the bonding layer and the different mixtures of NiCoCrAlY alloy and 3YSZ (3mol％ yttria stabilized zirconia) ceramic powders were used as the transitio

期刊

composite materialshot press sinteringthermal shock resistancethermal insulat

Effect of C/Mo Duplex-coating on Thermal Residual Stresses in SiCf/Ti2AlNb Composites

Three-dimensional finite element physical models considering the layered distribution of materials at the interface were developed to study the effect of the coating system on distributions of thermal residual stresses in SiCf/Ti2AlNb composites. Two coat

期刊

finite element simulationtitanium matrix compositeSiC fiberthermal residual s

Improvement of Ge MOS Electrical and Interfacial Characteristics by using NdAlON as Interfacial Pass

The Ge metal-oxide-semiconductor (MOS) capacitors were fabricated with HfO2 as gate dielectric. AlON, NdON, and NdAlON were deposited between the gate dielectric and the Ge substrate as the interfacial passivation layer (IPL). The electrical properties (s

期刊

Ge MOS capacitorinterfacial passivation layer (IPL)gate stacked dielectricint

Formation Mechanism of Impure Phases and Crystallinity Investigation of YAG Powders Synthesized via

We investigated the impure phase problem and summarized its two formation mechanisms of YAG powders synthesized via the co-precipitation method. The ions loss problem caused by high concentration reaction solution in the titration process was emphatically

期刊

transparent ceramicsphase transitioncrystallinityco-precipitationactivity co

Microstructure and Thermophysical Properties of Mg-Ga Alloys

The microstructure and thermal characteristics of Mg-36％Ga, Mg-43％Ga, and Mg45％Ga(wt％) alloys were investigated. The experimental results show that the microstructure of Mg-36％Ga alloy is mainly composed of primary α-Mg phase and α-Mg+Mg5Ga2 eutectic phas

期刊

Mg-Ga alloyphase change materialthermal energy storagelatent heat storage

Study on Camellia Oleifera Protein based Wood Adhesive by Epoxy Resin and Its Crosslinking Mechanism

Epoxy resin (EPR) was used to crosslink with Camellia oleifera Abel. protein to prepare wood adhesive, and the bonding performance and curing characteristics of which were mainly investigated, and the synthesis mechanism was also discussed by using model

期刊

Camellia oleifera proteinepoxy resincrosslinkingwood adhesive

Preparation and Dye Adsorption of Low-cost Polyaniline-tea Saponin Nanocomposites

Four polyaniline-tea saponin (PTS) nanocomposites were prepared by an in-situ polymerization with tea saponin (TS) as a biosurfactant, and they were used to remove organic dyes from aqueous solution. The PTS nanocomposites were characterized by using fiel

期刊

polyanilinetea saponinnanocompositeadsorption

氧化石墨烯改性聚酰胺膜研究进展

聚酰胺膜广泛应用于海水淡化、苦咸水脱盐及废水处理等领域,复杂、多类型的应用场景对膜性能提出了更高要求。氧化石墨烯(GO)以优异的机械、化学稳定性及亲水性等优点引起了学者的广泛关注。利用GO改性聚酰胺膜,可以改善膜的水通量、抗污染及耐氯性等性能。综述了聚酰胺膜在酸性和含氯溶液中的降解过程,介绍了GO结构特征,重点关注了利用GO在聚酰胺膜支撑层中、支撑层与功能层间、功能层中及功能层表面进行改性以提高膜性能的研究进展,对GO改性聚酰胺膜中金属离子及水传质过程进行了简要介绍。最后,提出未来可以从完善GO改性聚酰胺

期刊

纳米材料膜氧化石墨烯水处理污染

工业石膏的资源化利用途径与展望

电力、钢铁、磷肥等工业生产过程中产生大量副产石膏,如不能妥善处理而将其大量搁置,不仅造成环境污染,而且导致资源浪费.副产石膏的无害化、大综化、高质化利用,已经成为工业发展中的热点话题.对国内工业副产品石膏中脱硫石膏和磷石膏在水泥、建材、农业、化工等领域应用和技术开发现状进行了总结,并对未来工业石膏资源化利用提出了建议.以工业石膏为原料制备硫酸联产水泥、铁酸钙以及转铵法制备硫酸的工业路线具有可行性,有望实现脱硫石膏和磷石膏的大规模利用.

期刊

脱硫石膏磷石膏天然石膏综合利用

Antibacterial Activity and Mechanism of ZnO/Cu2+-Chitosan/Montmorillonite

A new composite antibacterial material ZnO/Cu2+-Chitosan/Montmorillonite (ZCCM) was prepared with montmorillonite as carrier, Zn(Ac)2?2H2O, Cu(NO3)2?3H2O and chitosan as raw materials. ZCCM was characterized by X-ray diffraction, nitrogen physical adsorpt

期刊

montmorillonitechitosanZnOCu2+antibacterial mechanism