一、6000t和3000t锻造水压机随动系统简介 锻造水压机操纵系统中的随动系统广泛采用机械液压位置随动系统。为了探索它们的技术改造途径,曾对某厂6000t和某某厂3000t锻造水压机随动系统进行了动态特性测试与初步理论分析,它们的原理图分别见图1、图2,原理框图见图3。 两台水压机随动系统都直接使用高压水作为动力源,随动阀为普通的 阀分配器,随动系统采用 A, 6000t and 3000t forging hydraulic press servo system introduction Forging hydraulic press control system servo system widely used mechanical hydraulic position servo system. In order to explore their way of technological transformation, a plant 6000t and a certain factory 3000t forging hydraulic press servo system dynamic characteristics of the test and preliminary theoretical analysis of their schematic diagram shown in Figure 1, Figure 2, the block diagram shown in Figure 3 . Two hydraulic servo system are directly using high-pressure water as the power source, servo valve for the ordinary valve distributor, servo system