建筑工程施工中,我看到有很多师傅在支带滴水檐雨篷模板时多采用铺两层底板法做滴水檐。这样做既费料又费工。下面介绍一种只铺一层底板法。支模法和一般雨篷模板支法基本一样。所不同的是,雨篷两侧要用两根特殊阁栅:用两根小面等于滴水檐宽、大面等于一般阁栅加底板厚、长等于雨篷挑出的长度的 During the construction of the construction project, I saw that many masters used the two-layer floor method to make drip drips when supporting dripping and awning formwork. This is both wasteful and laborious. The following describes a method of laying only one floor. The moulding method is basically the same as the general awning formwork method. The difference is that two special gutters are used on both sides of the awning: with two small faces equal to the width of the drip, the large face equal to the general gab and the floor thickness, and the length is equal to the length of the awning.