论文部分内容阅读
电火花线切割加工模具或齿轮渐开线齿廓之前,需先作曲线拟合,以便计算线切割编程数据.文章给出高精度的渐开线齿廓线曲线二点拟合法以及电火花线切割加工模具齿形和内齿精度简易检测方法.该方法对各种模具和圆柱齿轮的渐开线齿形加工均适用.
模具渐开线齿形的电火花线切割加工
【摘 要】
：
电火花线切割加工模具或齿轮渐开线齿廓之前,需先作曲线拟合,以便计算线切割编程数据.文章给出高精度的渐开线齿廓线曲线二点拟合法以及电火花线切割加工模具齿形和内齿精度
【机 构】
：
青岛建筑工程学院
【出 处】
：
制造技术与机床
【发表日期】
：
2004年6期
其他文献
The topological index of molecular graph is a number that attributed to the molecular graph and is valid than graph isomorphism, this number can reflect the pro
目前,世界一些发达国家的钨冶炼技术,也就是从钨精矿到APT(仲钨酸铵)的回收率一般为95～96％。在我们国家只有极个别厂家达到这个水平。株洲硬质合金厂,1988年成功地将碱压煮萃取
Effects of Processing Methods on Mechanical Properties of Alkali Treated Bagasse Fibre Reinforced Ep
Effects of the processing methods on the mechanical properties of treated bagasse fibre reinforced epoxy composite were evaluated. The composite materials were
Fabrication of Solvent-Resistant Nanofiltration Membrane via Interfacial Polymerization Based on Cel
Although a great progress has been achieved for the development of NF membranes and technologies and SRNF do show a great potential in the separation of organic
M1450磨床用二加工中小轧辊,由于故障致使工作台纵向移动活塞杆弯曲.该活塞杆分左右两件,直径50mm,长3500mm空心管状在全长三分之一部位产生一个45°左右的死弯,外侧受拉
针对现代数控机床高速、高精发展趋势,分析了机床进给系统应用直线电动机的优缺点.阐述了不同结构类型直线电动机的特点及其相应的应用场合.总结了直线电动机直接驱动伺服系
The use of coconut shell particulates to enhance the insulating refractory properties of Ukpor, Osiele and Kankara fireclays in Nigeria was studied in this pape
Localized residual strain develops within the metallurgical texture of 1018 carbon steel from metallurgical processes, such as fabrication, annealing, and shapi
文章对基于PC的开放式测控系统进行了简单论述.对于伺服控制环节,给出了由专用集成电路组成的简单可靠的硬件电路来驱动直流伺服电动机构成闭环位置控制系统.并提出了脉宽调
Phase Transformation, Technological Properties and Microstructure of Fired Products Based on Clay-Do
The present work reports the effect of carbonate addition to iron rich kaolinite on the phase transformation during firing. Mineralogical, thermal (including DT