【摘 要】
：
4.半年检查与维护 除包括月检查内容外还应有: (1)检查所有的减速器的齿轮啮合和磨损情况,齿面点蚀损坏不应超过啮合面的30％,且深度不超过原齿厚的10％(固定弦齿厚);齿轮的齿厚
【机 构】
：
北京重型电机厂机修分厂 北京市石景山区吴家村 100039
论文部分内容阅读
4.半年检查与维护 除包括月检查内容外还应有: (1)检查所有的减速器的齿轮啮合和磨损情况,齿面点蚀损坏不应超过啮合面的30％,且深度不超过原齿厚的10％(固定弦齿厚);齿轮的齿厚磨损量与原齿厚的百分比不得超过表9的规定值;检查轴承的状态;更换润滑油。
4. Six months of inspection and maintenance, in addition to including the monthly inspection should be: (1) check all gear meshing and wear, tooth pitting damage should not exceed 30% of the mating surface, and the depth of no more than the original Tooth thickness of 10% (fixed chord thickness); Gear tooth thickness wear and the percentage of the original tooth thickness shall not exceed the value specified in Table 9; Check the bearing status; Change the lubricating oil.
其他文献
在通风除尘管道的制造中常用的异形接头,其加工制造一般是先在金属薄板上画出展开图,然后落料加工成型。画展开图一般采用三角形法,这种方法在操作上较为繁琐,本人在实践中
The inception of the tip vortex cavitation (TVC) is a very important problem in cavitation researches. The study of the mechanism of the TVC inception is not on
今以左旋齿轮为例:将分度头安装在铣床工作台上,插律检查符合要求后装上斜齿轮。选择一个比较好的齿作为测量对象。将百分表座装在床身上,不随工作台移动,表头压在齿的一端A
Propulsive performance of a passively flapping plate in a uniform viscous flow has been studied numerically by means of a multiblock lattice Boltzmann method. T
热电偶在工业领域内应用非常广泛,凡要对机件温度进行监测的地方,大多是利用热电偶采样。我矿抽风机轴承温度的测量就是利用热电偶进行采样的。近几年因地方小井的乱采乱挖,
我厂使用的Z28-20滚丝机,其联轴器结构如图1所示。在滚压直径大于M30、材料为40Cr的螺栓时,联轴器结合子出现
I used Z28-20 rolling machine, the coupling structure sho
Based on theε-support vector regression, three modelling methods for the ship manoeuvring motion, i.e., the white-box modelling, the grey-box modelling and the
Interblade vortices can greatly influence the stable operations of Francis turbines. As visible interblade vortices are essentially cavitating flows, i.e., the
Background:Nonfluoroscopic three-dimensional electroanatomical system is widely used nowadays,but X-ray remains indispensable for complex electrophysiology proc