The effects of Y pre-alloying on the in-situ dispersoids of ODS CoCrFeMnNi high-entropy alloy

来源 :材料科学技术(英文版) | 被引量 : 0次 | 上传用户:fdgbh54g45g44
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Oxide dispersion strengthened CoCrFeMnNi high-entropy alloys(ODS-HEAs)were prepared using two different powder preparation methods classified by yttrium addition strategy to investigate the effects of in-situ and ex-situ oxide dispersoid formation on the microstructure and mechanical properties.System-atic microstructural analysis was carried out by X-ray diffraction(XRD),electron backscattered diffraction(EBSD),high-resolution transmission electron microscopy(HRTEM),atom probe tomography(APT),and small-angle neutron scattering(SANS).Cryo-milled powder analysis,grain structure evolution after spark plasma sintering,dispersoid characteristics,and matrix/dispersoid interface structure analysis of the in-situ and ex-situ dispersoids within the high-entropy alloy(HEA)matrix were performed.The in-situ dispersoid formation was dominantly observed in the Y-alloyed ODS-HEA through the construction of a coherent interface relationship with complex chemical composition,leading to an increase in the Zener pinning forces on the grain boundary movement.ODS-HEA with in-situ oxide dispersoids enhanced the formation of ultrafine-grained structures with an average diameter of330 nm at a sintering temperature of 1173 K.This study shows that the Y pre-alloying method is efficient in achieving fine coherent dis-persoids with an ultrafine-grained structure,resulting in an enhancement of the tensile strength of the CoCrFeMnNi HEA.
其他文献
Fibers degradation and matrix cracks are very common during fabrication of composites,which seri-ously reduces the reliability and properties of the composites.In this work,2D-Cf/ZrB2-SiC composites were fabricated by a joint processing of slurry infiltra
We demonstrate the fabrication of wearable supercapacitor electrodes.The electrodes were applied to wearable fabric by supersonically spraying the fabric with reduced graphene oxide(rGO)followed by decoration with iron oxide(Fe2O3)nanoparticles via a hydr
The worldwide outbreak of COVID-19 since December 2019 has caused great challenges to health organizations,and brought tremendous impact on the global economy.There have been over 62.3 million confirmed infection cases and 1.4 million deaths reported unti
期刊
Gradient boosting decision tree(GBDT)machine learning(ML)method was adopted for the first time to automatically recognize and conduct quantitative statistical analysis of boundaries in bainitic microstruc-ture using electron back-scatter diffraction(EBSD)
Increasing iron content has been witnessed an essential method to improve the remanence of 2:17-type Sm-Co-Fe-Cu-Zr magnets,however,the inferior squareness factor accompanied with the increased iron content turns into a neck sticking problem.In this work,
Layered lithium nickel-cobalt-manganese oxides(NCM)have been highlighted as advanced cathode materials for lithium-ion batteries(LIBs);however,their low interfacial stability must be overcome to ensure stable cycling performance of the cell.In this work,w
Na3(VO)2(PO4)2F(NVPOF)has been considered as one potential candidate for sodium-ion batteries because of its high operating voltage and theoretical capacity.However,the poor intrinsic electronic conductivity significantly restricts its widespread applicat
The controllable adjustment of electromagnetic(EM)properties for high-efficiency EM absorbents are indispensable,nonetheless,rare in crystals engineering regulation.Herein,for the first time,regulated amount of sodium citrate was employed as accessory lig
The influence of particle size and morphology on grain refinement in low stacking fault energy(SFE)alloys was studied by comparing the grain structures in single-and multi-phase Al-bronze(AB)alloys following equal channel angular pressing(ECAP)between 350
The effects of site occupation on the phase stability,martensitic transformation,and the magnetic and electronic properties of a full series of Ni-Mn-In alloys are theoretically studied by using the ab initio calculations.Results indicate that the excess