Design and Implementation of Visualized Workflow Modeling System Based on B/S Structure

来源 :东华大学学报(英文版) | 被引量 : 0次 | 上传用户:divide2058
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
According to the necessity of flexible workflow management system, the solution to set up the visualized workflow modelling system based on B/S structure is put forward, which conforms to the relevant specifications of WfMC and the workflow process definition meta-modei. The design for system structure is presented in detail, and the key technologies for system implementation are also introduced. Additionally, an example is illustrated to demonstrate the validity of system.
其他文献
A mathematical model is established on the basis of the physical characteristic of the negative resistance arc when a low current of 0-50 A is applied in pulsed
A novel approach, which combines spectrum adaptation and orthogonal frequency division multiplexing (OFDM), is proposed to share the licensed spectrum dynamical
提出了一种基于Catmull-Clark细分算法的自适应算法,自适应过程由离散点的曲率C来控制.计算多面体中各离散点的曲率,与已给定的曲率值相比较后,得出的可继续细分的点、边、面
在流动系统中,用半导体阵列激光器在低磁场下抽运Cs原子,由自旋交换碰撞产生极化的129Xe气体,在SY-80M核磁共振谱仪中,冻成固体和液体后的极化度分别为2.16%和1.45%,和相同条
研究负荷记录混沌的成因,对于提高短期负荷预报的准确率是必要的.通过对某地全年负荷记录时间序列及其差分序列的3 d时间窗口上的最大李雅普诺夫指数λ1的计算,发现全年各处
Mechanical properties of SMAW (shielded metal arc welding) weld metal (yield strength higher than 900 MPa) with systematic additions of copper (up to 1.48wt%) w
利用差示扫描量热曲线 (DSC)方法构筑了InCl3 /BPC二元体系相图 ,并指出该体系可形成含稀散金属的室温离子液体 ,有一定宽度的室温离子液体窗口和较小的室温离子液体深度 .从
研究了将旋转空间矢量算法应用于超导磁储能 (SMES)装置的可行性 ,比较分析了旋转空间矢量控制和传统矢量控制这两种控制算法在系统节点电压幅值或相位发生突变时的控制效果
This article summarizes the block process flow scheme for the 8.0 Mt/a refining project at Hainan Refining and Chemical Company, Ltd., highlighting a green rout
An FE model was developed to study thermal behavior during the rod and wire hot continuous rolling process. The FE code MSC.Marc was used in the simulation usin