论文部分内容阅读
图1为一弯曲件,一般在弯边机上弯曲。工作时,采用弯边机上的两个定位块定位。在弯曲中,操作工人需要时时用手去调整定位块,生产效率低,且不安全,不适合大批量生产。为此,我们设计了两副定位机构,经车间使用效果很好,提高生产率5～8倍,且安全可靠、操作方便。 1.工装结构定位机构(图2)安装在弯边机上。调整机床部件,使其定位块2与V形弯曲凹模中心线的距离为14mm,(见图3)弯曲件水平搁在弯边机的两个平行支架上。在定位块2的端面上可进行
Figure 1 is a curved piece, usually on the bending machine bending. Work, the use of crimping machine two positioning block positioning. In bending, the operator needs to adjust the positioning block with his hand from time to time. The production efficiency is low, and the safety is not suitable for mass production. To this end, we have designed two positioning mechanism, the effect of using the workshop is very good, improve productivity 5 to 8 times, and safe and reliable, easy to operate. 1. Tooling structure Positioning mechanism (Figure 2) installed in the crimping machine. Adjust the machine tool so that its positioning block 2 is 14 mm from the center line of the V-shaped bending die (see Figure 3). The bending piece rests horizontally on the two parallel brackets of the bending machine. The positioning block 2 can be carried out on the end face