CONCENTRATION DISTRIBUTION OF ALLOYING ELEMENTS IN SURFACE LAYER OF Ti ALLOY MELTS

来源 :Acta Metallurgica Sinica(English Edition) | 被引量 : 0次 | 上传用户:heshang9994
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The concentration distribution of alloying elements such as Al,Sn,V,Si and Mo in surfacelayer of quenched Ti alloy melts(TC4,TA 7 and TC9)has been determined by EPMA.Ti al-loy samples were melted and evaporized by electron beam in water cooled copper curc
其他文献
通过生物信息学的方法,利用拟南芥、水稻的MADS-box基因对草莓MADS-box基因家族进行鉴定和分析,共得到83个草莓MADS-box候选基因,且MADS-box结构域高度保守。进化分析表明,Fv
After70-90% cold-rolling,strong{111}〈110〉and weak {111},〈112〉 cold-rolled tex-tures and perfect{111}〈112〉 recrystallization texture were obtained in Fe-Si
The enthalpies of mixing for the PbCl<sub>2</sub>-NaCl-BaCl<sub>2</sub> ternary molten salt mixtures havebeen measured along four iso-αPbCl<sub>2</sub> Iines b
新课程理念要求,高效课堂是以学生的进步和发展为宗旨,教师必须具备一切为学生发展的思想,运用科学的教学策略,使学生愿学、爱学、乐学、会学,促进其全面发展、主动发展和个
通过对比和试验确定2214锻件锻造工艺参数和变形组织的过烧温度,研究其热处理工艺参数对材料组织和性能的影响.
A much higher elongation of a warm rolled superplastic Al-Li-Cu-Mg-Zr alloy was madeunder two-stage strain rate tests comparing with the single ones.During init
本文对B-RE共渗剂及其工艺进行了研究,结果表明,稀土在粉末渗硼中能有效地提高渗硼层的生长速度,所研制的渗硼剂性能稳定,渗速可提高20~30%。根据研究成果,提出了渗剂设计的基
Activity of TiO<sub>2</sub> in the molten blast furnace slag containing TiO<sub>2</sub> has been examinedat 1500℃ by means of “molten slag-Sn” chemical equil
评述了目前宏观经济分析中核心指标的使用情况,提出并论述了如下观点:分析宏观经济运行状态和过程必须采用社会总产值(TPS)作为核心指标,而分析宏观经济运行的结果和水平则应选择国民
The mechanical properties and microstructure of an Fe-base superalloy GH35A have beenexamined after aging at 650—750℃ for 100—10000 h.The tensile strength of