复合模自动退料机构采用滑板式自动退料,它分别与上、下模座连接,以压机的滑块6为动力,滑块上下运动带动拉杆7,使接料板8在滑杆9上往复运动(见附图)。滑块上行时,接料板就伸进上、下模之间接住从上模打下的工件;淆块下行时,接料板就退出,同时把工件送进压机旁的接料箱中进行重叠,实现了自动退料。这样既能节省工时,又能防止产生废品。操作简便、提高工 The compound type automatic withdrawal mechanism adopts a skateboard-type automatic withdrawal, which is respectively connected with the upper mold and the lower mold base. The slider 6 of the press is used as a power, and the slider moves up and down to pull the pull rod 7, Up and down (see photo). When the slider goes up, the splicing plate extends into the upper mold, and the lower mold picks up the workpiece laid from the upper mold. When the confusion block descends, the splicing plate withdraws, and at the same time, the workpiece is sent into the splicing bin beside the press Overlap, to achieve automatic withdrawal. This will not only save working hours, but also prevent the production of waste. Easy to operate, improve workmanship