1、浴霸电源配线系统要规范。浴霸的功率最高可达1100W 以上,因此,安装浴霸的电源配线必须是防水线,最好是不低干1mm 的多丝铜芯电线,所有电源配线都要走塑料暗管镶在墙内,绝不许有明线设置,浴霸电源控制开关必须是带防水10A 以上容量的合格产品,特别是老房子浴室安装浴霸更要注意规范。2、注意浴霸的厚度不宜太大。在安装问题上,消费者在选购时一定要注意 1, Yuba power wiring system to be standardized. Yuba power up to 1100W or more, therefore, the installation of Yuba power wiring must be waterproof, it is best not to dry 1mm multi-wire copper wire, all power wiring must go plastic inlay wall in the wall , Must not have a clear line set, Yuba power control switch must be waterproof with 10A capacity above qualified products, especially the old house bathroom Yuba more attention should be paid to regulate. 2, note that the thickness of the bath should not be too large. In the installation of the problem, consumers must pay attention to the purchase