A series of the copolymers of ethylene with 1-hexene(M1–M9) synthesized by metallocene catalyst Et[Ind]2ZrCl2/MAO was studied by differential scanning calorimetry and successive self-nucleation and annealing(SSA) thermal fractionation. The distribution of methylene sequence length(MSL) in the different copolymers was determined using the SSA method. The comonomer contents of samples M4 and M5 are 2.04 mol% and 2.78 mol%, respectively. Both M4 and M5 have low comonomer content and their MSL distribution profiles exhibit a monotonous increase trend with their MSL. The longest MSL of M5 is 167, and its corresponding molar percent is 43.95%, which is higher than that of M4. Moreover, the melting temperature(Tm) of M5 is also higher than that of M4. The comonomer contents of samples M7, M8, and M9 are 8.73 mol%, 14.18 mol% and 15.05 mol%, respectively. M7, M8, and M9 have high comonomer contents, and their MSL distribution profiles display unimodality. M7 has a lower peak value of 33 and a narrow MSL distribution, resulting in a Tm lower than that of M8 and M9. The MSL and its distribution are also key points that influence the melting behavior of copolymers. Sometimes, MSL and its distribution of copolymers have a greater impact on it than the total comonomer contents, which is different from traditional views. A series of the copolymers of ethylene with 1-hexene (M1-M9) synthesized by metallocene catalyst Et [Ind] 2ZrCl2 / MAO was studied by differential scanning calorimetry and successive self-nucleation and annealing (SSA) thermal fractionation. The distribution of methylene Both M4 and M5 have low comonomer content and their MSL distribution profiles exhibit a The longest MSL of M5 is 167, and its corresponding molar percentage is 43.95%, which is higher than that of M4. Moreover, the melting temperature (Tm) of M5 is also higher than that of M4. M7, M8, and M9 have high comonomer contents, and their MSL distribution profiles display unimodality. M7 has a lower peak value of 33 and a narrow MSL distribution, resulting in a Tm lower than that of M8 and M9. The MSL and its distribution are also key points that influence the melting behavior of copolymers. Sometimes, MSL and its distribution of copolymers have a greater impact on it than the total comonomer contents, which is different from traditional views.