论文部分内容阅读
In the article the results of measurements of the resultant force in th e legs of a powered roof support unit, caused by a dynamic interaction of the ro ck mass, are discussed. The measurements have been taken in the longwalls mined with a roof fall, characterized by the highest degree of bumping hazard. It has been stated that the maximal force in the legs Fm, recorded during a dynam ic interaction of the rock mass, is proportional to the initial static force in the legs Fst,p. Th erefore a need for a careful selection of the initial load of the powered roof s upport, according to the local mining and geological conditions, results from su ch a statement. Setting the legs with the supporting load exceeding the indispen sable value for keeping the direct roof solids in balance, deteriorating the ope rational parameters of a longwall system also has a disadvantageous influence on the value of the force in the legs and the rate of its increase, caused by a dy namic interaction of the rock mass. A correct selection of the initial load caus es a decrease in the intensity of a dynamic interaction of the rock mass on powe red roof supports, which also has an advantageous influence on their life.rn Simultaneously with the measurements of the resultant force in the legs, the vertical acceleration of the canopy was also recorded. It has enabled to prove that the exte rnal dynamic forces may act on the unit both from the roof as well as from the f loor. The changes of the force in the legs caused by dynamic phenomena intrinsic ally created in the roof and changes of the force in the legs caused by blasting explosives in the roof of the working, have been analyzed separately. It has been stated that an increase in the loads of legs, caused by intrinsi c phenomena is significantly higher than a force increase in the legs caused by blasting. It means that powered roof supports, to be operated in the workings, w here the bumping hazard occurs, will also transmit the loads acting on a unit du ring blasting. The majority of recorded force changes in the legs has been caused by a dyna mic interaction of the roof. They are characterized by a load increase coefficie nt Kd, satisfying the inequality 1.06
其他文献
This paper presents a study on the criterion of crack initiation and propagation under creep conditions, which were investigated using specimens collected from outcropped sandstone rock formations. Beam specimens under three points bending were used in th
The target of the text is to scientifically appraise dynamic development of surface deformation in subsidence area and its influence on groundwork stability of natural pipe and then adopt some technological measures to ensure safe circulation of natural p
Being a safe and highly-efficient mining method, fully mechanized mining with sublevel caving (FMMSC) was extensively employed in Chinese coal mines with thick seam. In order to make drawing top-coal furthest to parallel work with shearer cutting coal,dec
Pit optimisation is the earliest and most established application of its kind in the minerals industry,but this has been primarily driven by metal,not coal.Coal has the same financiaI drivers for resource optimisation as does the metalliferous industry,ye
Numerical simulation of influence of shear dilatancy on deformation characteristics of shear band-el
The paper was numerically focused on investigation of deformation, failure and instability of shear band-surrounding elastic rock system in plane strain direct shear test considering shear dilatancy according to fast lagrangian analysis of continua (FLAC)
Numerical simulation for rheological characteristics of alternating distribution of soft and hard ro
The difficulty of selecting appropriate rheological model and parameters for the alternating distribution of soft and hard rock layers was often encountered due to the unhomogeneity, discontinuity and anisotropy of rock mass. The Burgers and generalized K
HIGH-RESOLUTION SEQUENCE DIVISION AND TRANSGRESSIVE EVENTS COAL FORMATION IN SOUTHEASTERN NORTH CHIN
The sea level changes in the Paleozoic epicontinental basin were of high frequency and the transgressive events were episodic.This kind of sea level changes controlled both the basin filling and the coal accumulation within the basin.Coal accumulation in
Back-and-forth mining for hard and thick coal seams-research about the mining technology for fully m
The article introduced the key technology, mining process, and back-and-forth mining method for the caving working face of hard-thick coal seams in Datcng mine, and researched this innovations process, optimized the systemic design and working face outpla
The current practice of rock/coal outburst monitoring, prevention and control was reviewed. The uncertainty of major factors contributing to the occurrence of such hazards and the complexicity of mining conditions surrounding the occurrence were analyzed.
The change rules of displacement field characteristics of coal seam and tunnel\'s surrounding rock were obtained by means of numerical simulation-FLAC3D and site observation, and according to engineering geology and exploitation technology of 1151 (3)fu