把气缸从车上卸下来,用汽油洗净(特别是沙眼或裂纹处)。接着用200号的沙布把沙眼裂纹处磨光,然后,用酒精棉球擦净,凉干,再用环氧树脂和聚酰胺分别按1:1的比例搅拌均匀,涂在沙眼或裂纹处,涂的面积不要太小,以防脱落,将气缸置放在20°以上的环境里(也可放在炉子旁烤),待其充分凝固后,即可装车使用。此法也可用于曲轴箱、齿轮箱、油箱的修复。 Remove cylinder from vehicle and wash with petrol (especially trachoma or crack). Then with the No. 200 Shabu to trachment cracks at the trachoma, and then wipe with alcohol cotton balls, dry, and then the epoxy resin and polyamide were 1: 1 ratio of Stir, painted in the trachoma or crack , Painted area should not be too small, to prevent falling off, the cylinder placed in more than 20 ° environment (also on the stove next to the roast), to be fully solidified, you can load the use of. This method can also be used for crankcase, gear box, tank repair.