Enhanced coking resistance of a Ni cermet anode by a chromates protective layer

来源 :能源化学 | 被引量 : 0次 | 上传用户:xingyu9404
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Ni-based anodes of SOFCs are susceptible to coking,which greatly limits practical application of direct methane-based fuels.An indirect internal reformer is an effective way to convert methane-based fuels into syngas before they reach anode.In this work,catalytic activity of a redox-stable perovskite La0.7Sr0.3Cr0.8Fe0.2O3-δ (LSCrFO) for methane conversion was evaluated.The catalyst was fabricated as an anodic protective layer to improve coking resistance of a Ni cermet anode.Using wet CH4 as a fuel,the LSCrFO-modified cell showed excellent power output and good coking resistance with peak power density of 1.59W cm-2 at 800 ℃.The cell demonstrated good durability lasting for at least 100h.While the bare cell without the protective layer showed poor durability with the cell voltage fast dropped from 0.75V to 0.4V within 30min.Under wet coal bed methane (CBM) operation,obvious performance degradation within 35 h (1.7 mV h-1) was observed due to the influence of heavy carbon compounds in CBM.The pre-and post-mortem microstructures and carbon analysis of the anode surface and catalyst surface were further conducted.
其他文献
Organometal halide perovskites have recently emerged with a huge potential for photovoltaic applica-tions. Moreover, preparation of high-quality perovskite crystals with controlled morphology is of great significance for the fundamental studies such as op
In this paper In2O3 nanoshells have been synthesized via a facile hydrothermal approach.The nanoshells can be completely cracked into pony-size nanocubes by annealing,which are then used as a support of Pt catalyst for methanol and ethanol electrocatalyti
Lithium-sulfur (Li-S) batteries have been recognized as promising substitutes for current energy-storage technologies owing to their exceptional advantages in very high-energy density and excellent material sustainability.The cathode with high sulfur area
One-dimensional nano-structured materials have attracted attention due to its unique properties afforded such as the across-linked structures and large aspect ratios. In this work, one-dimensional CoSe@N-doped carbon nanofibers (CoSe@NC NFs) are successfu
One of the major challenges associated with fuel cells is the design of highly efficient electrocatalysts to reduce the high overpotential of the oxygen reduction reaction (ORR).Here we report Polyaniline (PANI) based micro/nanomaterials with or without t
Organometal halide perovskite based solar cells have emerged as one of the most promising candidates for low-cost and high-efficiency solar cell technologies.Here a Vapor Transfer Method (VTM) is used to fabricate high quality perovskite thin films in a b
2D nanosheets such as graphene,silicene,phosphorene,metal dichalcogenides and MXenes are emerging and promising for lithium storage due to their ultrathin nature and corresponding chemical/physical properties.However,the serious restacking and aggregation
Lithium sulfide (Li2S) provides a promising route for lithium storage due to high theoretical specific capacity (1166 mAh g-1).The electrochemical performance of Li2S can be significantly enhanced by forming Li2S-carbon composites with the introduction of
Development of efficient and promising bifunctional electrocatalysts for oxygen reduction and evolution reactions is desirable.Herein,cobalt nanoparticles embedded in nitrogen and sulfur co-doped carbon nanotubes (Co@NSCNT) were prepared by a facile pyrol
Wormholelike mesoporous carbons (WMCs) with three different pore diameters (Dp),namely WMC-F7 (Dp =8.5 nm),WMC-F30 (Dp=4.4nm),and WMC-F0 (Dp=3.1 nm) are prepared via a modified sol-gel process.Then PtRu nanoparticles with the panicle size (dpt) of ~3.2 nm