论文部分内容阅读
我单位在装配热风整平机时,遇到一个问题:即从调节能输出的高压气体,需送入空气风刀中去,两者之间是通过高压胶管连接起来的.由于该机设计十分紧凑,调节器的输出端至空气风刀的输入端距离很近,且不在同一个平面上,有两处须圆弧过渡.由于圆弧处的半径R小于胶管允许的最小弯曲半径r,因此胶管在圆弧处出现打折现象,影响高压气体在胶管中的流动.打折现象严重时,高压气体将被堵塞在胶管中.若出现上述情况,热风整平机将不能正常工作;设备的使用性能将大幅度下降.
My unit assembly hot air leveling machine, encountered a problem: that is, from the regulation can output high-pressure gas, air knife to be sent to the air, the two are connected by a high-pressure hose. Because the machine design is very Compact, the output of the regulator to the air-knife input close to the distance, and not in the same plane, there are two arcs to be due to arc radius R is less than the hose allows the minimum bending radius r, therefore Hose in the arc at a discount phenomenon, affecting the high-pressure gas flow in the hose.When the discount is serious, the high-pressure gas will be blocked in the hose.If the above situation, the hot air leveling machine will not work; equipment performance Will drop significantly.