在NaOH-烯丙基氯-DMSO体系中合成烯丙基蔗糖的新方法

来源 :中国化学工程学报(英文版) | 被引量 : 0次 | 上传用户:zxjz520
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Allylsucrose has been prepared by reaction of sucrose with allyl chloride in the NaOH-DMSO system.DS (average degree of substitution) of allylsucrose calculated by elemental analysis was 6.7, and the efficiency of allyl chloride was 83.7%. The mechanism of the reaction was based on the acceleration of base-catalyzed reactions in dipolar aprotic solvents. The novel method is facile and suitable for large-scale preparation.
其他文献
Sebisty effect describes the unusual fact that the thickness of the hot-dip galvanizing coating on the steel containing 0.12%-0.25% silicon decreases with incre
A tunable dual-broad-band branch-line coupler (BLC) utilizing composite right/left-handed (CRLH) transmission lines is presented. Two λ/4 segments consisting o
MoS2 coatings were prepared by unbalanced bipolar DC magnetron sputtering under different argon pressures and for different deposition times, and the structure
Nominal composition of Ca1 - xZnxTiO3: 0. 002Pr3 + ( x = 0. 000 ~ 0. 200) phosphors were prepared by conventional solid reaction route. XRD and PL measurements w
Through the differentiating and integrating process, a mathematical model for tempering time effect on quenched steel was derived based on the attribute of stat
Application of amorphous V2O5/carbon/neodymium oxide (Nd2O3) composite is one of ways to surmount the lower electrical conductivity of V2O5. A new type of V2O5/
The variations of electrical conductivity and hardness across the thickness of an Al alloy 7010 plate under the temper condition T7651 were investigated. The el
The joining of graphite, ceramic SiC and Cf/SiC composites via preceramic silicone resin(SR) at high temperature (800-1400℃) was studied. The curing and pyroly
An attempt has been made to study the influence of wear parameters like applied load, sliding speed, sliding distance and percentage of reinforcement on the dry
Oil-air two-phase flow measurement was investigated with a Venturi and void fraction meters in this work. This paper proposes a new flow rate measurement correl