针对700mm以上的高料层烧结过程中,出现烧结过程料层透气性恶化的问题,在太钢技术中心进行了采用支撑板改善烧结过程料层透气性的烧结杯试验研究,试验结果表明:采用350mm高度支架支撑作用效果最好,料层收缩显著降低,利用系数提高了15.2%,转鼓强度保持原有水平,烧结矿冶金性能改善。 Aiming at the problem that the permeability of the material layer in the sintering process is deteriorated during the process of high material layer above 700mm, the sintering cup experiment using the support plate to improve the gas permeability of the material during the sintering process is conducted in the TISCO Technical Center. The experimental results show that: The effect of 350mm height support is the best, the shrinkage of material layer is significantly reduced, the utilization coefficient is increased by 15.2%, the drum strength is maintained at the original level, and the metallurgical properties of sinter are improved.