【摘 要】
：
为克服端出料加热炉结构上的缺点,试验了无闲区端出料轧钢加热炉。由于消除了旧炉结构中的“死闲区”,解决了由于炉门吸入大量冷空气而造成的严重缺点,减少了烧损,提高了加热
论文部分内容阅读
为克服端出料加热炉结构上的缺点,试验了无闲区端出料轧钢加热炉。由于消除了旧炉结构中的“死闲区”,解决了由于炉门吸入大量冷空气而造成的严重缺点,减少了烧损,提高了加热质量,可节约燃料27.5％左右。
In order to overcome the shortcomings of the structural structure of the end discharge heating furnace, the discharge furnace with no discharge end was tested. Due to the elimination of the “furnace free zone” in the old furnace structure, the serious shortcomings caused by the large amount of cold air inhaled by the furnace door are solved, the burning loss is reduced and the heating quality is improved, which can save fuel by about 27.5%.
其他文献
本文的目的是要探讨板内新生代火山活动分布,以及它与对流所产生的岩石圈拉张应力场的关系。一般认为,地球的火山活动大部分是在地幔对流涡的上升翼中由于地幔岩石的压力解
On the 31 of August,1932,the writer of the present paper was ap-pointed one of the five members by the National Geological Survey,Peking tosurvey the soils of
国务院关于修改《国务院关于于职工工作时间的规定》的决定中规定:国家机关、事业单位实行统一的工作时间,星期六和星期日为周休息日。企业和不能实行前款规定的统一工作时间
[答]:可调节的手铰刀是可以铰钢套、铁套的。过去有的单位曾规定可调节的手铰刀不能用于铰钢套、铁套,主要原因是可调节手铰刀的价格比一般手铰刀贵,怕影响可调节手铰刀的耐
In the territory leased to Great Britain, which lies to the South of the Sam Chun river, there are many small areas of sedimentary rocks. A series of red beds,
As a consequence of the evergrowing attention paid to the mineral resourcesof Yunnan,the Chungitsun~1 phosphate deposit becomes inspiring and attractiveto indu
本书叙述了钻孔人工造斜的技术手段和工艺、小口径钻孔自然弯曲度的研究方法、纠斜手段和方式;叙述了钻孔人工造斜和辅助井筒设计效率的评价方法;系统列举了现代定向钻孔标
为了减少剃齿刀的品种、降低成本,本文提出了盘形剃齿刀的简明复算法,通过对剃齿刀和齿轮啮合时节圆上法向啮合角α_1、端面上有效啮合线长度上的必须超越值△l、径向间隙△
All the triassic reptiles so far described from Sinkiang wereDicynodontia.It is therefore of special interest to describe from thesame formation a completely d
我们通过对美、加会计职业后续教育规划、组织、管理、协调和实施现状进行实地考察,取得了大量有关会计职业后续教育现状与未来发展趋势的第一手资料,我们认为美、加的一些