我厂使用的机械夹固组合刀排其结构如图所示。经五年多来使用证明,能节省刀具材料,操作方便,加工的端盖质量和产量均有提高。该刀排可加工端盖的轴伸孔、轴承室、止口,轴承室底面、端面及止口底面、端面。刀排用于端盖加工的半精车和精车二个工步,精车量为0.1～0.2毫米,转速在200-400转/分之间,进刀量不大于0.24毫米/转。 I plant the use of mechanical clamp combination knife row structure as shown. After more than five years of use proved that the tool material can be saved, easy to operate, the processing of the cover quality and yield have increased. The knife row can be machined end shaft shaft bore, bearing chamber, only port, bearing chamber bottom, end and stop the bottom, end. Knife row for the end cover machining semi-fine car and fine car two steps, fine car volume of 0.1 to 0.2 mm, speed of 200-400 rev / min, feed rate of not more than 0.24 mm / rev.