油压表感应器接头(图1),是用四方铜棒料加工而成。过去在C615车床上加工,由于加工工件批量较大,工人劳动强度很高。因为工序变换频繁,床头需搬转角度,车床齿轮易损坏,床面局部磨损也较严重,同时还占用了一台通用车床。我厂一车间的同志们,利用一台破旧车床,改装制成了一台管接头简易自动车床,它可以车外圆、倒角、打中心孔、挑扣及切断,各工序连续自动进行,提高效率5倍,加工质量满足要求,同时还减轻了工人的劳动强度。机床结构见图2。四方铜棒料由主轴1后端推入,至顶上定位螺钉17为止。电动机20带动主轴1旋转,经齿轮减速后, Hydraulic gauge sensor connector (Figure 1), is processed with square copper rod material. In the past in the C615 lathe processing, because the processing of large quantities of workpieces, high labor intensity. Because of frequent process changes, the bed should be rotated angle, lathe gear easy to damage, the bed is also more serious local wear and tear, but also takes up a universal lathe. I plant a workshop comrades, the use of a shabby lathe, converted into a simple automatic pipe joints, which can be car round, chamfer, hit the center hole, pick buckle and cut off, the process of continuous automatic, Improve efficiency 5 times, processing quality to meet the requirements, but also reduce the labor intensity of workers. Machine structure shown in Figure 2. Quartet copper rods from the rear end of the spindle 1 pushed to the top of the set screw 17 so far. The motor 20 drives the spindle 1 to rotate, and after the gear is decelerated,