The need for cleaner fuels has resulted in a continuing worldwide trend to reduce diesel sulfur and aromatics. There are many approaches to reducing sulfur and aromatics in diesel. Most of them have a common drawback of high cost because of adopting two stages of hydrotreating and using noble-metal catalyst, especially for reducing aromatics. The attempt to resolve this issue has led to the recent development of the Single Stage Hydrotreating (SSHT) process by Research Institute of Petroleum Processing (RIPP), SINOPEC.The SSHT process is a single-stage hydrotreating technology for producing low sulfur and low aromatics diesel. The process uses one or two non-noble-metal catalysts system and operates at moderate pressure. When revamping an existing unit to meet low aromatics diesel specification, the only thing to do is to add a reactor or replace the existing reactor, In pilot plant tests, the SSHT technology has successfully treated SRGO (Straight Run Gas Oil), LCO (Light Cycle Oil) or the blend of them. It is shown that by using the SSHT process diesel with sulfur of 30 ppm and aromatics of 15 m% can be produced from Middle-East SRGO and diesel with aromatics content of 25 m% can be produced from cracked feed, such as FCC-LCO. High diesel yield and cetane number gain (from cracked feed stocks) give the SSHT technology a performance advantage compared to conventional hydrocracking and hydrotreating processes.The lower investment and operating cost is another advantage. The first commercial application of the SSHT technology has been in operation since September 2001.