Synthesis of the Core-Shell Structure Materials as the Controlled-Release Drug Carrier

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:wobushilaji
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
We have developed a controlled-release drug carrier. Smartly controlled-release polymer nanoparticles were firstly synthesized through RAFT polymerization as the controlled-release core. The structural and particle properties of polymer nanoparticles were characterized by nuclear magnetic resonance spectroscopy (1H-NMR), scanning electron microscope (SEM) and X-ray spectroscopy (EDX). Mesoporous materials were selected as the shell materials to encapsulate the smart core as the stable shell. The mesoporous shell was characterized by transmission electron microscopy (TEM) and scanning electron microscope (SEM). All the results showed that a well-defined core-shell structure with mesoporous structure was obtained, and this controllable delivery system will have the great potential in nanomedicine.
其他文献
The rare earth doped TiO2 was prepared and characterized with Nd,Ho and Y as the doping agents,which have obvious absorption in visible light area.The particle size of the glomeration was about 200-400 nm.TiO2 sensor performed a significant change in resi
Red mud was firstly used as a raw material in sintering field road cement. Then, the radioactive element distribution characteristics of red mud based field road cement (RFC) before and after hydration were comparatively investigated. The experimental res
Phase pure ZrB2-SiC composite powders were prepared after 1 450 ℃/3 h via carbothermal reduction route,by using ZrSiO4,B2O3 and carbon as the raw materials.The influences of firing temperature as well as the type and amount of additive on the phase compos
The Lap-joint configuration and the vacuum assisted forming method were put forward to meet the demands of the compression bending strength and the strong connection between the steel and FRC.The bending mechanic tests of the Lap-joint bending specimens c
To obtain the influence laws of the fine gangue rate on the properties of coal gangue cementitious paste, the slump, divergence, stratification, bleeding, setting time and mechanical strength with the change of fine gangue rate were studied on the basis o
The aim of this work was to investigate the effect of waste paper fiber on the properties of cement-based mortar and the relative mechanism. The cement-based mortars with various contents and mixing way of waste paper fibers were prepared and the slump fl
By using redispersible polymer powder (RPP) and carbon fiber (CF) to adjust the flexibility and electrical properties of the smart aggregate, a new kind of smart aggregate with Z type structure was proposed. The study shows that Z type aggregate is more s
An attractive way to prepare W/TaC based cermet at a relatively low temperature was proposed and confirmed experimentally. The thermodynamics calculations indicated that the reaction between WC and Ta2O5 was feasible at as low a temperature as 1400 ℃. The
The influence of air-cooled blast furnace slag aggregates as replacement of natural aggregates on the water absorption of concrete and mortar was studied, and the mechanism was analyzed. The interface be-tween aggregate and matrix in concrete was analyzed
The stress–strain behavior and strain rate sensitivity of pre-strained Ni80Cr20 (Ni20Cr) were studied at strain rates from 4.8×10–4 s–1 to 1.1×10–1 s–1. Specimens were prepared through cold drawing with abnormal plastic deformation. The texture of the spe