【摘 要】
：
In order to improve the burn-resistant property of titanium (Ti) alloy, Ti-molybdenum (Mo) burn-resistant alloyed layer is coated onto the Ti6Al4V substrate with the double glow plasma surface alloying technology by permeating the Mo. The experiment is pe
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
In order to improve the burn-resistant property of titanium (Ti) alloy, Ti-molybdenum (Mo) burn-resistant alloyed layer is coated onto the Ti6Al4V substrate with the double glow plasma surface alloying technology by permeating the Mo. The experiment is performed at a working temperature of 800 oC to keep the layer warm for 2.5 h under air pressure of 30 Pa. Mo and Ti6Al4V are used as the source electrode and cathode, respectively. The result of X-ray diffraction shows that the alloy phase of Ti and Mo is formed on the surface of Ti6Al4V substrate. The hardness of the alloyed layer on the surface is more than 800 HK. The friction result further indicates that wear rate can be reduced by three orders of magnitude. Laser ablation experiment is used to characterize the burn-resistant properties of the Ti alloy. The result indicates that the laser burn area of the treated Ti alloy is reduced to 1/12 of the untreated sample. Moreover, the burn-resistant properties improved greatly. Current experimental results clearly show that the laser ablation can be used to characterize the burn-resistant property of the material.
其他文献
利用ANSYS有限元模拟软件,建立了激光熔凝RuT300三维实体有限元模型,考虑了激光吸收率、材料热物性参数及相变潜热的影响,通过分析不同预热温度下激光熔凝的瞬态温度场,获得预热温度对温度分布、温度梯度、冷却速率等的影响规律。结果表明,随着预热温度的增大,试样相同位置处的最高温度增大,预热温度对试样下部的温度场影响更明显;随着预热温度的增大,试样相同位置处的温度梯度减小,当距离试样上表面的深度达到约2 mm时,试样的温度梯度受预热温度的影响不明显;对试样进行预热处理可降低试样的冷却速率,冷却速率随着预热温
激光在动平衡中的应用,还是一项较新的技术.本文对用调Q激光脉冲去重(汽化)和非调Q脉冲去重的特点作了初步介绍.对于具有高生产率的“两级平衡法”和“横向激励大气压二氧化碳激光器的平衡系统”作了介绍.最后对于进一步工作提出了一些看法.
激光-电弧复合焊接是焊接领域的研究热点，工业应用前景广阔。保护气体是实现激光-电弧有效复合、获得最大效能的关键参数。结合国内外研究及作者的研究工作，综述了保护气体成分、配比、流量等参数对激光-电弧复合焊接工艺特性、焊缝形貌特征和接头力学性能的影响及研究现状。
Metals in nature exhibit a mediocre wettability and a high optical reflectance from the visible region to the infrared. This Letter reports that, by formation of nano- and microscale structures via a simple raster scanning of a focused femtosecond laser p
Based on the principle of Fabry-Perot (F-P) interference, a new type of optical fiber curvature sensor is presented, which is fabricated by single-mode fiber (SMF), ceramic tube and double-cladding fiber (DCF). And the curvature sensing properties are ana
法国国家电信研究中心(CNET)的工程师们发展了一种原型全光学市区网路，它不但可用于传输，而且还可用于信号处理和转换。直到现在为止，对于其它功能均采用较为普通的电子技术的系统来说，其光通讯作用基本上只限于宽带的传输。
The feasibility of applying optical coherence tomography (OCT) in determining the degree of myocardial ischemia-reperfusion injury is assessed. The left anterior descending coronary artery of 90 Sprague-Dawley rats are ligated and reperfused at different
对使用其他金属氯化物（BiCl3, FeCl2或NaCl)搀和剂的低温纯铜蒸汽激光器进行了研究。使用BiCl3搀和剂时得到的激光特性最好。