【摘 要】
：
Based on the orbital angular momentum and pulse position modulation, we present a novel passive measure-ment-device-independent quantum key distribution (MDI-QKD) scheme with the two-mode source. Combining with the tight bounds of the yield and error rate
【机 构】
：
ElectronicEngineeringCollege,NavalUniversityofEngineering,Wuhan430033,China
【出 处】
：
OptoelectronicsLetters
论文部分内容阅读
Based on the orbital angular momentum and pulse position modulation, we present a novel passive measure-ment-device-independent quantum key distribution (MDI-QKD) scheme with the two-mode source. Combining with the tight bounds of the yield and error rate of single-photon pairs given in our paper, we conduct performance analysis on the scheme with heralded single-photon source. The numerical simulations show that the performance of our scheme is significantly superior to the traditional MDI-QKD in the error rate, key generation rate and secure transmis-sion distance, since the application of orbital angular momentum and pulse position modulation can exclude the ba-sis-dependent flaw and increase the information content for each single photon. Moreover, the performance is im-proved with the rise of the frame length. Therefore, our scheme, without intensity modulation, avoids the source side channels and enhances the key generation rate. It has greatly utility value in the MDI-QKD setups.
其他文献
针对异源图像配准中传感器物理特性差异造成的待匹配特征维度较高、稳定性较弱、配准质量较差等问题,提出一种基于尺度不变特征变换(SIFT)的异源图像配准方法。该方法首先结合相位一致性和改进的SIFT算法获得稳定的特征,然后利用最近邻距离比方法进行初匹配,接着提出了一种联合误差与欧氏距离(JEED)方法进行再匹配,最后采用模式搜索尺度不变特征变换(MS-SIFT)方法优化匹配点对以提高图像配准质量。实验结果表明,相比于现有方法,所提方法能够提取可靠稳定的特征,获得了较高配准质量,同时提高了配准算法的实时性。
为了研究300M低合金超高强度钢激光焊接接头的组织和力学性能,采用光纤激光器对300M钢进行自熔焊对接试验,结合拉伸测试等分析方法研究了焊接接头的焊缝形貌、组织变化特征和力学性能,讨论了焊缝金属快速凝固过程中的相变。结果表明:300M低合金超高强度钢激光焊接接头的焊缝横截面呈典型的“Y”形;焊缝金属主要由柱状树枝晶组成;焊缝组织主要由马氏体以及残余奥氏体组成。靠近焊缝的热影响区分为硬化区和软化区,硬化区的硬度约为734 HV,软化区的硬度约为456 HV,接头的断裂位置为软化区,接头的抗拉强度为1269
报道了一种新型组合式(2X×列阵)同轴双程放大器──“神光-Ⅱ”实验装置的主放大器,净通光口径为φ200 mm.以及在单束原型机上取得的判断实验和理论计算的结果。
1970年长波(红外)激光装置采用碲化镉之后，其应用将大大增加。美帝休斯飞机公司的研究表明，这种电-光材料可能成为目前广泛使用的砷化镓（GaAs)的主要竞争者。
Broadband (1.6–18 THz) terahertz time-domain spectroscopy (THz-TDS) and time-resolved terahertz spectroscopy (TRTS) were performed on a 54 μm thick chalcogenide glass (As30Se30Te40) sample with a two-color laser-induced air plasma THz system in transmissi
We investigate the spectra of the gain and pump-to-signal relative intensity noise (RIN) transfer in silicon optical parametric amplifier (SOPA) with Raman effect, and draw a conclusion that Raman effect makes the spectra narrower from 260 nm to 180 nm. A
利用非本征型光纤法布里珀罗干涉仪(EFPI)和光纤布拉格光栅(FBG)制作了一种温度和应力同时测量的复合光纤传感器。采用超高真空磁控溅射镀膜、电镀及激光焊接技术实现了光纤传感器的耐高温全金属无胶化封装。实验结果表明：在290 ℃温度条件下传感器的应力灵敏度为90 pm/N，具备良好的线性测量能力（约0.9965）；传感器的温度灵敏度为12 pm/℃，线性度可达到0.9988，其温度补偿效果较好。实验结果同时证明了采用超高真空磁控溅射镀膜及激光焊接技术实现光纤传感器耐高温全金属化封装方法的可行性与有效性。
分析了辐射行波场Wiggler自由电子激光器的工作状态,计算了激光器的增益,分析了获得正增益的条件。