论文部分内容阅读
采用大型有限元程序ＡＮＳＹＳ５．５的ＦＬＯＴＲＡＮ１４１单元研究了加热介质流量变化对Φ２０００ｍｍ×３２００ｍｍ鼓式硫化机硫化鼓温度分布的影响。研究表明，模拟结果与实际相符，对于加热介质从硫化鼓一端进入夹套从另一端流出的结构形式，欲使鼓面最大温差不大于５℃，要求加热介质流量为２００ｍ３／ｍｉｎ。加热介质流量太大会导致过多的能量损失，因而不经济
The influence of the change of heating medium flow on the temperature distribution of curing drum of Φ2000mm × 3200mm drum vulcanizer was studied by FLOTRAN141 unit of large finite element program ANSYS5.5. The results show that the simulation results are in accordance with the actual situation. For the heating medium entering the jacket from one end of the curing drum and flowing out from the other end, the maximum temperature difference of the drumhead is not more than 5 ℃, and the heating medium flow rate is 200m3 / min. Too much heating medium flow can lead to excessive energy loss and thus uneconomical