【摘 要】
：
In order to distinguish the filling effect and volcanic activity and explore the ways motivating the activity of rich-silicon iron ore tailing(IOT),inert quartz was brought in as the correction standard,the influences of fineness,calcination,thermal curin
【机 构】
：
State Key Laboratory of Silicate Materials for Architecture, Wuhan University of Technology, Wuhan 4
【出 处】
：
武汉理工大学学报（材料科学版）（英文版）
论文部分内容阅读
In order to distinguish the filling effect and volcanic activity and explore the ways motivating the activity of rich-silicon iron ore tailing(IOT),inert quartz was brought in as the correction standard,the influences of fineness,calcination,thermal curing system and some other factors were investigated by IR,XRD,MIP,and so on microscopic methods.The experimental results show grinding and calcination can only change the amorphous state of SiO2,and IOT do not have volcanic activity in concrete cured under room temperature condition.Thermal curing systems can stimulate the activity of IOT,especially mortar cured by autoclave curing system can consume a large amount of Ca(OH)2 and hard calcium silicate and has a closer structure.When the specific surface area of IOT powder is 800 m2/kg,and 30％ cement is replaced by IOT powder,the mortar strength with IOT powder is even higher than that with cementonly.
其他文献
Walnut-shell activated carbons (WSACs) were prepared by the KOH chemical activation. The effects of carbonization temperature, activation temperature, and ratio of KOH to chars on the pore development of WSACs were investigated. Fourier transform infrared
Palygorskite/paraffin phase-change composites were prepared by the combination of purified palygorskite clay and sliced paraffin. Then, this composite was used in the Trombe wall to improve its energy storage ability. Further, its energy storage ability w
Four Nb-Ti microalloyed steels were refined and rolled to study the composition optimization of Nb-Ti microalloyed steels.The effects of Nb and Ti on the microstructures,precipitates and properties of Nb-Ti microalloyed steel were investigated.The results
The functional groups on graphene sheets surface affect their dispersion and interfacial adhesion in polymer matrix. We compared the mechanical property of polymethymethacrylate (PMMA) microcellular foams reinforced with graphene oxide (GO) and reduced gr
The damage mechanism and energy dissipation of the Polyethylene (PE) laminates in impacting was investigated. It was found that the dissipated energy of the impacting sphere bullet by the 1-mm-thick PE plate firstly increased with the impacting velocity i
In order to examine the effect of extrusion ratio on the microstructure and mechanical behavior in Al-Cu-Mg-Ag alloy, the Al-6.3Cu-0.48Mg-0.4Ag alloy was subjected to extruding with different extrusion ratios of 17, 30 and 67. The results indicate that th
Banana pseudo-stem was liquefied in the mixture of polyhydric alcohols of polyethylene glycol (PEG400) and glycerol. Hydroxyl value of liquefied products ranged from 294.8 to 370.2 mg KOH/g and Mn was about 430. Liquefied products (LBPP) could be used as
The dynamic load characteristics of a proton exchange membrane fuel cell (PEMFC) with a dead-ended anode were studied. In a 70 h experiment, the effects of anode pressure, operating temperature, and relative humidity of the cathode on the performances of
To enhance the understanding about the utilization of steel slags as a cementitious material, we comparatively studied the chemical, mineralogical and morphological properties of two types of steel slag; basic-oxygen-furnace carbon slag (BOF C) and electr