论文部分内容阅读
加料冲天炉采用各种加料机械或手工装料,随时都有发生事故的可能,因此,机械运料车附近除必须设置栅栏外,严禁行人穿过和靠近。加料机运行时,应当有红色警灯和警铃,提醒人们注意。冲天炉加料应高出加料平台0.5m。在加料口测量底焦高度时,要用足够长度的量棒测量,测量时严禁向炉内探身。加料平台要保持整齐清洁。加料前要对废钢废铁料进行严格检查,将废旧炮弹、武器、各种压力容器,密封空桶等挑出,或经特殊处理后才能入炉,以免
Feeding cupola using a variety of feeding machinery or manual loading, at any time there may be an accident, therefore, in addition to the vicinity of the mechanical haul truck must be set outside the fence, pedestrians are not allowed to pass through and close to. Feeder operation, there should be red lights and alarm bell, to remind people’s attention. Cupola feeding should be higher than feeding platform 0.5m. When measuring the bottom coke height at the feeding port, it is necessary to measure with a measuring rod of sufficient length, and it is strictly prohibited to lean into the furnace when measuring. Feeding platform to keep neat and clean. Before feeding the scrap iron scrap to be strictly checked, the used shells, weapons, all kinds of pressure vessels, sealed empty barrel, etc. singled out, or after special treatment into the furnace, so as not to