A Multi-phase Field Model for Static Recrystallization of Hot Deformed Austenite in a C-Mn Steel

来源 :金属学报(英文版) | 被引量 : 0次 | 上传用户:xiaorixue
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
A multi-phase-field model has been developed to simulate the microstructure evolution and kinetics of the austenite static recrystallization (SRX) in a C-Mn steel.In this model,the bulk free energy that coupling the deformation stored energy with a special interpolation function is incorporated.Both the deformed grain topology and the deformation stored energy have been included in order to investigate the influence of pre-deformation on the subsequent austenite SRX at different hot deformation levels.Diverse scenarios of microstructure evolution show different deformation-dependent recrystallized grain sizes.The transformation kinetics is then discussed by analyzing the overall SRX fraction and the average interface velocity on the recrystallization front.
其他文献
Magnesium matrix composites reinforced with AlN particles were fabricated by the powder metallurgy technique. Different mixing methods were used in this study to control the distribution of AlN particles. The microstructure, thermal diffusivity and therma
A facile polyol-assisted pyro-synthesis method was used to synthesize Co3O4 nanoparticles embedded into carbon matrix without using any conventional carbon source.The surface analysis by scanning electron microscopy showed that the Co3O4 nanoparticles (~2
A polymethyltrimethoxysilane (PMTMS)/hydroxyapatite (HA) hybrid coating was successfully fabricated on a magnesium alloy by hydrothermal treatment and immersion method.The microstructure and composition of the coating were characterized by using X-ray dif
The growth behavior of Al3Ni intermetallic compounds (IMCs) during the directional solidification of Al-10 wt% Ni alloy was investigated by synchrotron radiography. Two main growth patterns of primary Al3Ni phase, I-like and V-like, appeared during solidi
Sand-cast Mg-9Gd-4Y-0.5Zr (wt%) alloy was solution-treated at 500-565 ℃ in the time range of 0.5-30 h in air or vacuum to investigate its microstructure evolution and mechanical properties.The results showed that solution treatment temperature had a signi
The different solution and migration behaviors of tetrahedral and octahedral interstitial helium in bcc iron have been investigated by using first principles calculations.We showed that the tetrahedral site has less charge transfer and less redistribution
The Mg-8Sn-4Zn-2Al (TZA842,in wt%) alloys with different initial microstructure (as-cast-AC and homogenization treatment-HT) subjected to hot extrusion.Also,the strengthening responses to AC and HT for the extruded TZA842 alloys were reported.The results
In order to investigate the effect of microstructural characterization on the mechanical properties and retained austenite stability,a different type of quenching and partitioning steel (I-Q&P) through intercritical annealing before the quenching and part
Spherical Nb-20Si-24Ti-2Cr-2Al pre-alloyed powders were processed by selective laser melting (SLM) on Ti6Al4V substrates with different energy densities.A series of single tracks and single layers were produced using different processing parameters,includ
In order to investigate the microstructure and mechanical property evolution of low-carbon reduced activation ferritic/martensitic (RAFM) steel during isothermal aging,the normalized and tempered specimens were aged at 600 ℃ for 500,1000,and 3000 h,respec